%3. PARTS REPLACEMENT - 3.1 Precautions Concerning Parts Replacement 3. PARTS REPLACEMENT
This section covers the procedures for the disassembly, reassembly and installations in the field. This
section describes the disassembly procedures, and for reassembly procedures, basically proceed with
the disassembly procedures in the reverse order.
3.1 Precautions Concerning Parts Replacement Note: Always use good anti-static methods. (1) Parts
replacements must be carried out, by first turning the printer power switch off [O] and removing the
Multi-Purpose Feeder from the printer. (2) Do not disassemble the Multi-Purpose Feeder if it is operating
normally. (3) Establish the extent of disassembly suitable for the purpose of the procedure, and do not
disassemble any more than necessary. (4) Use only specified service tools. (5) Disassembly must be
carried out according to the prescribed procedures. Parts may be damaged if such procedures are not
followed. (6) Small parts such as screws and collars can easily be lost, therefore these parts should be
temporarily fixed in the original location. (7) When handling printed circuit boards, do not use gloves,
which may generate static electricity.
(8) Do not place the printed circuit boards directly on the equipment or floor.
[Service Tools]
Table 3-1 shows the tools required for the replacement of printed circuit boards and units in the field.
Table 3-1 Service Tools
OKI OL600/610ex (96-01-18