Menu setting method

4

method setting Menu

EN

Notes

•The recording level will be automatically adjusted when the recording level is set to [Auto]. Set the recording level to [Manual] to use the recording level adjustment feature.

•When the unit is set to [Auto], the limiter function will be disabled. When a loud sound is produced the level meter will swing all the way over to the right while recording and the PEAK/LED indicator light will turn on. When this happens the sound will be recorded in a distorted manner since the recording level is too high. If sound distortions do not disappear even after the recording level has been adjusted, change the setting for microphone sensitivity (☞ P.65) and adjust the recording level again.

•If too big sound is input, the noise may occur even if [Rec Level] is set to [Auto] or [Limiter ON].

•The level can be adjusted from [01] to [12]. The higher the number, the higher the level and the larger the indicator position on the level meter.

Low Cut Filter A N

The recorder has a Low Cut Filter function to minimize low-frequency sounds and record voices more clearly. This function can reduce noise from air conditioners, projectors and other similar noises.

[Off]:

Disables this function.

[100Hz]:

This setting will reduce the noise generated from air conditioners or projectors. It is effective for indoor recording.

[300Hz]:

Use this setting when sufficient effects cannot be obtained with the [100 Hz] setting.

Note

•When the [Input Jack] setting is set to [Line], the Low Cut Filter function is disabled (☞ P.67).

Self Timer A N

The self-timer function allows a certain amount of time to elapse after you fully press the REC (s) button and then starts recording or shooting. Set this function according to the purpose of recording or shooting.

[Off]:

Disables this function. [beep 5sec]:

A beep tone sounds for 5 seconds and the PEAK/LED indicator light flashes from 3 seconds before recording or shooting starts.

[beep 12sec]:

A beep tone sounds for 12 seconds and the PEAK/LED indicator light flashes from 3 seconds before recording or shooting starts.

[metalic5sec]:

A rhythm count tone sounds for 5 seconds and the PEAK/LED indicator light flashes from 3 seconds before recording or shooting starts.

[metalic12sec]:

A rhythm count tone sounds for 12 seconds and the PEAK/LED indicator light flashes from 3 seconds before recording or shooting starts.

Notes

•To cancel the self-timer after it starts press the STOP (4) button.

•Self-timer shooting is automatically canceled after one shot.

•When the [LED] setting is set to [Off], the LED does not flash during self-timer operation. After the time set for the self-timer elapses, recording or shooting starts automatically (☞ P.73).

•When the [Beep] setting is set to [Off], beep does not sound during self-timer operation. After the time set for the self-timer elapses, recording or shooting starts automatically (☞ P.73).

66