Omega CNI8DV, CNI16D Analog Output Enable/Disable Submenu, Current/Voltage Submenu, Reading

ANALOG OUTPUT ENABLE/DISABLE SUBMENU:

Press b 5) Scroll though the available selection until ENBL displays to use Analog Output Retransmission (output proportional to the input signal).

Press d 6) Display shows STRD stored message momentarily and then advances to CURR or VoLT Submenu only if it was changed, otherwise press a to advance to CURR or VoLT Current/Voltage Submenu.

If DSBL Analog Output Disabled was selected, all submenus of Analog Output Menu will be skipped and the meter will advance to ALR2 Alarm 2 Menu. If ENBL Analog Output Enabled was selected, Output 1 would be automatically Disabled, and reassigned as Analog Output.

CURRENT/VOLTAGE SUBMENU:

Press	d	7) Display flashes CURR Current or VoLT Voltage.
Press	b	8) Scroll through the available selection: Current or Voltage
		(Example VoLT ).
Press d		9) Display shows STRD stored message momentarily and then
		advances to RD1 Submenu only if it was changed, otherwise
		press a to advance to RD1 Reading 1 Submenu.
READING 1:
Press	d	10)	Display flashes 1st digit of previous “Reading 1” value.
Press	b & c 11) Enter “Reading 1” value. (Example 0000)
Press d		12)	Display advances to OUT.1 Out 1 Submenu.
OUT 1:
Press	d	13)	Display flashes 1st digit of previous “Out 1” value.
Press	b & c 14)		Enter “Out 1” value. (Example 00.00)
Press d		15)	Display advances to RD!2 Reading 2 Submenu.
READING 2:
Press	d	16)	Display flashes 1st digit of previous “Reading 2” value.
Press	b & c 17)		Enter “Reading 2” value. (Example 9999)
Press d		18)	Display advances to OUT.2 Out 2 Submenu.
OUT 2:
Press	d	19)	Display flashes 1stt digit of previous “Out 2” value.
Press	b & c 20)		Enter “Out 2” value. (Example 10.00)
Press d		21)	Display advances to the ALR2 Alarm 2 Menu.

The above example is for 0-10 V of the entire range of the Process Input and Analog Output. For 0-20 mA output you need to set “Analog Type” to Current and OUT 2 to 20.00.

30