Omega CNI8DH manual ALARM 2 DISPLAY COLOR SUBMENU, Example, Display Colors change sequences, Green

ALARM 2 DISPLAY COLOR SUBMENU:

Press d 11) Display flashes previous selection for “Alarm 2 Color Display”. Press b 12) Scroll through the available selections: GRN, RED or AMBR. Press d 13) Display shows STRD stored message momentarily and then

momentarily shows the software version number, followed by RST Reset, and then proceeds to the Run Mode.

IN ORDER TO DISPLAY ONE COLOR, SET THE SAME DISPLAY COLOR ON ALL THREE SUBMENUS ABOVE.

If user wants the Display to change color every time when both Alarm 1 and Alarm 2 are triggered, the Alarm values should be set in such a way that Alarm 1 value is always on the top of Alarm 2 value, otherwise value of Alarm 1 will overwrite value of Alarm 2 and Display Color would not change when Alarm 2 is triggered.

Example 1:

Output 1 & Output 2 = SSR

Alarm Setup: Absolute, Above, Alarm 2 HI Value “ALR.H” = 200, Alarm 1 HI Value “ALR.H” = 400

"Color Display" Setup: Normal Color “N.CLR” = Green, Alarm 1 Color “1.CLR” = Amber, Alarm 2 Color “2.CLR” = Red

Display Colors change sequences:

GREEN

RED

AMBER

•--➤	------------------------------•-----------------------------	•------------------------------	➤
0	AL2.H = 200	AL1.H = 400
	Example 2:
	Output 1 & Output 2 = Pulse

Alarm Setup: Absolute, Below, Alarm 2 Low Value “ALR.L” = 300, Alarm 1 Low Value “ALR.L” = 100

Color Display Setup: "N.CLR" = Green, "1.CLR" = Amber, "2.CLR" = Red

Display Colors change sequences:

AMBER

RED

GREEN

•	➤--------------	•----------------------------------	•-------------------------------------------	➤--•
0		AL1.L = 100	AL2.L = 300

56