Omega Speaker Systems VR200 List of Program Set Commands, Setting the Range and Scale

2.2 Program Set Commands

2.2.1 List of Program Set Commands

Command Type	Command	Function
	SR	Sets the input range and display scale.
	SA	Sets the alarms.
	SN	Sets the engineering unit.
	SW	Sets the waveform span rate.
	SD	Sets the date and time.
	SY	Copies the channel settings.
Set	SZ	Sets the discrete (zone) display.
	SP	Sets the partial expanded display.
	SK	Sets whether to display the scale values.
	ST	Sets the tag number.
	SL	Sets the trip level.
	SF	Sets the floppy disk format.
	SG	Sets the data file names.
	SC	Sets the LCD brightness and saver function.
	SM	Sets the messages.
	SH	Sets the number of division of the bar graph scale.
	SX	Sets wether to display the span rate and message menu.
	MD	Sets the waveform display and scale display.

Note

For restrictions concerning settings, refer to the instruction manual for the VR200.

2.2.2 Setting the Range and Scale

(See Section 4.1 of the instruction manual for the VR200.)

SKIP

Skips scanning the specified channel, i.e., prevents that channel from being measured, recorded and displayed.

Format: SRp1,mode

p1:	Channel number (CC)
mode:	SKIP

Example: SR01,SKIP

VOLT, TC, RTD, and DELT

Format: SRp1,mode, p2, p3, p4

p1:	Channel number (CC)
mode:	VOLT, TC, RTD, or DELT (difference computation between the
	specified channel and the reference channel)
p2:	Specification of the range
	For mode VOLT: 20mV, 60mV, 200mV, 2V, 6V, or 20V
	For mode TC: R, S, B, K, E, J, T, N, W, L, or U
	For mode RTD: JPT or PT (or, optionally CU1, CU2, CU3, CU4,
	CU5, CU6, or CU25)
	For mode DELT: the reference channel number. Note that the
	reference channel number must be lower than the channel number
	specified in p1.
p3:	Enter the low limit value of the display span within 5 digits
	excluding the decimal point and the + or - sign.
p4:	Enter the high limit value of the display span within 5 digits
	excluding the decimal point and the + or - sign.

2 - 2