Omega Speaker Systems VR200 List of Program Control Commands, Standard Screen Call

2.3 Program Control Commands

2.3.1 List of Program Control Commands

Command Type	Command	Function
	UD	Returns the screen to the standard screen.
	AK	Acknowledges the alarm(s).
	MI	Initializes the data memory.
	EV	Writes a time-axis mark or raises a manual trigger.
	BO	Specifies the bit sequence in bytes (for binary output).
Control	TS	Specifies which data value is to be output.
	FM	Specifies the data format of the measured value to be output.
	LF	Specifies the channel for the request for the set value (TS1 command) or the
		unit and decimal point (TS2 command).
	LO	Loads the specified SET configuration file.
	LI	Saves the settings (made in SET mode) with the specified file name.
	ME	Write the messages.
	UM	Switch the display

2.3.2 Standard Screen Call

(For the standard screen, see Section 1.6.1 of the instruction manual for the VR100 or the VR200.)

Command	Function
UD0	Returns the screen to the standard screen.
UD1	Returns the digital values for channels 1 to 3.
UD2	Returns the digital values for channels 4 to 6.
UD3	Returns the digital values for channels 1 to 6.

2.3.3 Alarm Acknowledge

(See Section 3.3 of the instruction manual for the VR100 or the VR200.)

Command	Function
AK0	Starts the alarm acknowledge function.

2.3.4 Initializing the Data Memory

(See Section 5.3 of the instruction manual for the VR100 or the VR200.)

Command	Function
MIYES	Initializes the data memory.

2.3.5 Writing a Time-axis Mark and Raising an Event Trigger

(See Sections 3.5 and 3.7 of the instruction manual for the VR100 or the VR200.)

Command	Function
EV0	VR100 and VR200 with style number 1 or lower: Writes a time-
	axis mark.
	VR200 with style number 2 or higher: Writes a message 1.
EV1	Raises a manual trigger.
	The manual trigger is effective only when the sample mode is set
	to trigger-on or trigger-rotation and the key trigger is set to ON.

2.3.6 Designating the Sequence of Byte Output (for Binary Output)

Command	Function
BO0	Designates that the measured values are to be output from the most
	significant byte (see Page 3-4).
BO1	Designates that the measured values are to be output from the least
	significant byte (see Page 3-4).

2 - 10