APPENDIX A
DEFAULT PARAMETERS
DEFAULT PARAMETERS
Loading Default Operating Parameters The control parameters can be loaded with predetermined default values. These are the settings loaded into the instrument prior to shipment from the factory. To load the default values proceed as follows:
a ) Press and hold the 
key and press the 
key; the displays will show:
b)Press either the 
or 
key; the display will show:
c) Press the "FUNC" key; the display will show:
This indicates that the loading procedure has been initiated. After about 3 seconds the loading
procedure is complete and the instrument reverts to the “Normal Display Mode.” The following is a list of the default operating parameters loaded during the procedure:
Default Operating Parameters List
Parameter | Default Value | ||
Alarm Acknowledge | OFF | ||
Software Key | Unlock | ||
Setpoint | Threshold | Low range value (if low limit) | |
|
|
| High range value (if high or |
|
|
| high/low limit) |
Setpoint1 | Threshold | Low range value | |
Setpoint | Threshold |
| |
Hysteresis | 0.1% | ||
Alarm | Threshold | Low range (if process alarm) | |
|
|
| 100 (if deviation or band |
|
|
| alarm) |
Alarm | Hysteresis | 0.1% | |
Appendix A.1
1 | 19/04/2004, 15.28 |
