One for All URC-8305 warranty Learning Feature, Learning direct, Before you start

Learning Feature

(How to copy functions from your original working

remote onto the KAMELEON 5)

The KAMELEON 5 comes with a complete library of pre-programmed codes. After you have set up the KAMELEON 5 for your device, you may find that there are one or more keys that you had on the original remote control, which do not have a place on the KAMELEON 5 keypad.

The KAMELEON 5 offers a special Learning feature that allows you to copy almost any function from your original remote control onto the keypad of the KAMELEON 5.

Before you start:

-Make sure your original remote is working correctly.

-Make sure neither your KAMELEON 5, nor your original remote control is pointing at your device.

Learning (direct)

Example: To copy the “mono/stereo” function from your original TV remote control onto the ”red”-key of your

KAMELEON 5.

1.Place the KAMELEON 5 and your original remote control on a flat surface. Make sure the ends which you normally point at your device are facing each other. Point the original remote to the front of the KAMELEON 5 (see picture below). Keep the remotes at a dis- tance of 2 to 5 cm (0.8 to 2 inches).

2.

3.

4.

5.

Press and hold down the MAGIC key (for about

3 seconds). The screen will change to the setup screen.

Press LEARN.

Press the device key (Example: TV key) on the KAMELEON 5 remote to select the mode to which you want to place the learned function.

Press the key (Example: “red” key) on the KAMELEON 5 remote where you want to place the learned function. The IR Indicator will show “incoming IR” three times and then the dis- play will switch off.

6.Press and hold the key that you want to copy (Example: mono/stereo) on your original remote control. The display switches back on and you will see two blinks to indicate successful learning operation.

7.If you want to copy other functions within the same mode, simply repeat steps 5 and 6 pressing the next key you want to copy by learning. If you want to copy another function in a different mode, simply continue with step 4 followed by steps 5 and 6.

8. Press ENTER to exit the learning mode and return to the setup screen OR press and hold ESC to return to the user screen.

WWW. ONEFORALL.COM 15