Onkyo CBX-300 Installing the iPod Dock Adapters, About the iPod Dock Adapters, A A B B, En-15

Installing the iPod Dock Adapters

About the iPod Dock Adapters

The supplied iPod dock adapters can be used with a wide range of iPod models (4th Generation and photo) and iPod mini, however, if the Apple iPod Universal Dock Adapter that fits your iPod is available, it is recom- mended that you use it instead.

If you have a 5th Generation or later iPod or an iPod nano, be sure to use the dock adapter that came with it.

The CBX-300 comes with two dock adapters. Each adapter has a letter on the rear, A or B, as shown below, so you can determine which iPod models it supports.

A A

B B

Installing the iPod Dock Adapters

1.Removing the dock’s protective cover

Keep the protective cover in a safe place so that you can put it back on if you don’t intend to use the dock for an extended period.

CBX-300’s top Protective cover

Push the tab forward and lift off the protective cover

2.Installing the dock adapter

Hold the adapter with its slot facing away from you and push it into the dock until it clicks into place.

The following table shows which iPod models are sup- ported by each adapter. Be sure to use the correct adapter for your iPod.

	iPod model		A	B
		20 GB
	MENU
		(including U2	✔
		Special Edition)
		40 GB
4th Generation iPod and				✔
U2 Special Edition
	MENU
			✔
	iPod mini
		30 GB	✔
	MENU
		40 GB		✔
		60 GB		✔
	iPod photo

Notes:

•Inserting your iPod into the CBX-300’s dock without the appropriate adapter installed will damage the dock connector. Even if the correct adapter is installed, don’t rock your iPod forcibly while it’s inserted in the dock, as this will also damage the dock connector.

•When you insert or remove your iPod, carefully move it straight into or out of the dock at the same angle as the dock connector.

Make sure the slot is at the rear.

Removing the Dock Adapters

To remove the dock adapter, insert a small flathead screwdriver into the slot, and lift it out, as shown below.

En-15