CRB8.book 38 ページ ２００５年８月１８日 木曜日 午後６時４０分
Listening to an FM/AM Station—Continued
Using the Remote Controller
Press the number buttons as described in the examples below to select the desired preset channel.
Preset Press channel
8
10
22
represents the tens digit.
Selects an FM/AM station.
Enables you to manually tune in a broadcast station.
(See the following section.)
Adjust the volume level.
(Pressing VOLUME 
increases the volume level, and pressing VOLUME decreases the level.)
Selects a preset channel.
(Pressing 
selects a lower channel number and pressing 
selects a higher channel number.)
Manually Tuning a Broadcast Station
1 | 2 |
| YES/MODE |
1Turn on the power to the CD receiver.
2Select FM or AM.
3 Press 
or 
repeatedly while observing the display to tune in the desired frequency.
Each press of the button changes the frequency by
0.05MHz for FM and 9 kHz for AM. Pressing and holding down the button for more than one second will change the frequency continuously.
While FM is selected, pressing and holding 
or
down a while, then releasing it, will automati- cally raise (or lower) the frequency.
When using the remote controller, press INPUT 
/
to select FM or AM, and press | / | to tune |
in the desired frequency. |
|
|
38
If FM reception is not good
If reception is poor or much noise is heard, press YES/ MODE to turn off the AUTO indicator and switch to monaural reception. In this way, you can reduce noise or dropped signals. To return to AUTO tuning, press YES/ MODE again.
CD receiver
AUTO 
FM ST
SOURCE
SOURCE
Remote
controller
