Onkyo CR-B8 Connecting an Onkyo Compact Disc Recorder, About the OPTICAL DIGITAL OUT Connector

CRB8.book 20 ページ ２００５年８月１８日 木曜日 午後６時４０分

Connecting External Devices—Continued

Connecting an Onkyo Compact Disc Recorder

The following diagram illustrates how to connect an optional Onkyo compact disc recorder.

Connect the CD receiver HDD OUT jacks to the disc recorder’s IN (REC) jacks. Connect the CD receiver HDD IN jacks to the disc recorder’s OUT (PLAY) jacks.

About the OPTICAL DIGITAL OUT Connector

You can connect a CD or DAT recorder that has an optical digital audio input to the CD receiver for digital recording. Use a standard optical digital audio cable for connection. Digital recording is allowed only for the first generation.

CD receiver’s rear panel

Analog audio cable (RCA)

red

white

red

white

An cable that comes with the compact disc recorder

		Jacks on the compact
			disc recorder’s
			rear panel
white	ANALOG			DIGITAL INPUT
	IN		OUT	REMOTE
	(REC)		(PLAY)	CONTROL	OPTICAL
				1	2
	L			L
red	R			R
white
red

Optical digital audio cable

: Signal flow

If any Onkyo CD recorder with terminals is connected, you must change the source name in the display so that the system can operate properly for the Direct Change function, etc.

Display

1

2 3-5

1 Press INPUT / until HDD appears in the dis- play.

2Press EDIT/NO/CLEAR repeatedly until “Name Select?” appears in the display.

3Press MULTI JOG.

4Turn MULTI JOG to select a CD-R name for the source.

5Press MULTI JOG to enter the new name.

You may press YES/MODE instead of MULTI JOG to get the same result.

The jack connection enables you to use the following functions:

•You can control a connected Onkyo compact disc recorder using the supplied remote controller. You also need to connect the analog audio cable.

•When the connected Onkyo compact disc recorder plays back, the input selector on the CD receiver is automatically switched to CD-R.

•When a CD recorder and a stereo cassette tape deck are connected with the CD receiver, you must also interconnect

the terminals between the two external devices.

•If a component has two terminals, you can use either one to connect to the CD receiver. The other one can be used to daisy chain with another component.

20