CRB8.book 43 ページ ２００５年８月１８日 木曜日 午後６時４０分
Naming Preset Channels—Continued
Inserting a Character
If the unit is not in “Name In” mode, execute steps 1 and 2 in “Entering a Name,” then follow the steps below.
1Press 
/ repeatedly until the character following the desired point of insertion flashes.
2Turn MULTI JOG until “ 
” appears, then press MULTI JOG.
3Enter the desired character (or title) as per Steps 3 and 4 in “Entering a Name.”
To continue entering characters, follow Step 3 in “Enter- ing a Name” on the previous page. To complete the oper- ation, follow Step 5.
Erasing the Name Assigned to a Preset Channel
1Select AM or FM as the source.
2Turn MULTI JOG to select the preset channel name you wish to erase.
3Press EDIT/NO/CLEAR and turn MULTI JOG until “Name Erase?” appears in the display.
4Press YES/MODE.
“Complete” appears and the name is erased.
Inputting Characters from the Remote Controller
3
3
1
4
2, 3
1
2
3
4
Press EDIT/NO/CLEAR.
Press ENTER.
Press DISPLAY repeatedly until the character type you wish to enter appears in the display.
Each press of the DISPLAY button switches the type of characters.
•Inputting alphabetical characters:
Each press of a number button cycles through a few characters of the alphabets. For example, repeat-
edly pressing the 2ABC button dis- plays A→B→C→A in this order. Display the desired character, then press ENTER.
•Inputting numbers and symbols:
Pressing a number button displays the corresponding number. Each press of the >10 button or the 10/0 ( 
) button switches between the
symbols labeled on the correspond- ing button. You can input “
→ .
→ / → * → - →, → ! → ? → & → ’→ ( → ) ” using the >10 button, and 
(space) using the 10/0 but- ton. Display the desired number or symbol, then press ENTER.
Note:
You cannot input all symbols from the remote controller’s number buttons. To input symbols, use the remote control-
ler’s 
or 
button to select the desired symbols.
Press YES/MODE/SHUFFLE to complete the naming process.
43
