Onkyo HT-R980 Recording, Zone, Others, Can’t record, There’s no sound, Stand-bypower consumption

To control an Onkyo component that’s not connected 61 via u, point the remote controller at the compo- nent. Be sure to enter the appropriate remote control code first.

The entered remote control code may not be correct. — If more than one code is listed, try each one.

Recording

■ Can’t record

On your recorder, make sure the correct input is	—
selected.
To prevent signal loops and damage to the AV	—
receiver, input signals are not fed through to outputs
with the same name (VCR/DVR IN to VCR/DVR
OUT).

Zone 2

■There’s no sound

Only components connected to analog inputs can be — played in Zone 2.

■The Zone 2 speakers produce no sound

To use the Zone 2 speakers, you must set the “Front 54 High/Zone2” setting to “Zone2”.

Others

■Stand-by power consumption

In the following cases, the power consumption may 49, 56 reach up to a maximum of 50W:

1.You are using the Universal Port jack.

2.“HDMI Control (RIHD)” setting is set to “On”. (Depending on the TV status, the AV receiver will enter Standby mode as usual.)

■The sound changes when I connect my headphones

When a pair of headphones is connected, the listen- — ing mode is set to Stereo, unless it’s already set to Stereo, Mono, or Direct.

■The speaker distance cannot be set as required

In some cases, corrected values suitable for home	—
theater use may be set automatically.

■How do I change the language of a multiplex source

Use the “Multiplex” setting on the “Audio Adjust” 42 menu to select “Main” or “Sub”.

■The functions System On/Auto Power On and Direct Change don’t work for components connected via u

These functions don’t work when Zone 2 is turned 17 on.

■When performing “Audyssey 2EQ® Room Correction and Speaker Setup”, the measurement fails showing the message “Ambient noise is too high.”.

This can be caused by any malfunction in your	—
speaker unit. Check if the unit produces normal
sounds.

■The following settings can be made for the composite video inputs

You must use the buttons on the unit to make these set- tings.

1.While holding down the input selector button for the input source that you want to set, press SETUP.

2.Use e/rto change the setting.

3.Press the input selector button for the input source that you want to set when you’ve finished.

• Video Attenuation

This setting can be made for the BD/DVD, VCR/DVR,

CBL/SAT, GAME, or AUX input.

If you have a games console connected to the composite video input, and the picture isn’t very clear, you can attenuate the gain.

Video ATT:OFF: (default).

Video ATT:ON: Gain is reduced by 2 dB.

The AV receiver contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.

Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s malfunction. Before you record important data, make sure that the material will be recorded cor- rectly.

Before disconnecting the power cord from the wall out- let, set the AV receiver to Standby.

■The ufunctions don’t work

To use u, you must make an uconnection and an 17 analog audio connection (RCA) between the compo- nent and AV receiver, even if they are connected dig- itally.

En

67