Onkyo SR804 Speaker Connection Precautions, Connecting the Speaker Cables, Strip about 5/8

Connecting Your Speakers—Continued

Speaker Connection Precautions

Read the following before connecting your speakers:

•You can connect speakers with an impedance of between 4 and 16 ohms. If the impedance of any of the connected speakers is 4 ohms or more but less than 6, be sure to set the minimum speaker impedance to 4 ohms (see page 46). If you use speakers with a lower impedance, and use the amplifier at high volume lev- els for a long period of time, the built-in amp protec- tion circuit may be activated.

•Disconnect the power cord from the wall outlet before making any connections.

•Read the instructions supplied with your speakers.

•Pay close attention to speaker wiring polarity. In other words, connect positive (+) terminals to only positive

(+) terminals, and negative (–) terminals to only nega- tive (–) terminals. If you get them the wrong way around, the sound will be out of phase and will sound unnatural.

•Unnecessarily long or very thin speaker cables may affect the sound quality and should be avoided.

•Be careful not to short the positive and negative wires.

Doing so may damage the AV receiver.

•Don’t connect more than one cable to each speaker termi- nal. Doing so may damage the AV receiver.

•Don’t connect a speaker to several terminals.

Connecting the Speaker Cables

1	Strip about 5/8" (15	5/8" (15 mm)
	mm) of insulation from
	the ends of the
	speaker cables, and
	twist the bare wires
	tightly, as shown.
2	Unscrew the terminal.
3	Fully insert the bare
	wires.

4 Screw the terminal tight.

The following illustration shows which speaker should be connected to each pair of terminals.

If you’re using only one surround back speaker, connect it to the left (L) SURROUND BACK SPEAKERS termi- nals.

Surround	Surround
back left	back right	Front left	Front right
speaker	speaker	speaker	speaker

Surround left	Surround	Center
speaker	right speaker	speaker

21