Turning On the Receiver
ON/STANDBY |
| |
|
| |
| VCR/DVR |
|
| GAME | TV/TAPE |
Turning On and Standby
Press the [ON/STANDBY] button. Alternatively, press the remote controller’s [] button.
The receiver comes on, and the display lights up.
To turn the receiver off, press the [ON/STANDBY] button, or press the remote controller’s [] button. The receiver will enter Standby mode. To prevent any loud surprises when you next turn on the receiver, always turn down the volume before you turn it off.
Note:
If you can’t use the remote controller to turn the receiver on/off, make sure that REMOTE MODE is set correctly.( page 9)
Changing the Input Display
For the [TV/TAPE], [VCR/DVR] and [GAME] buttons, the input display name can be changed as shown below.
When the input display name has been changed for one of the buttons below, the display name for the other button cannot be changed.
•[TV/TAPE] button : TV/TAPE DOCK
•[VCR/DVR] button : VCR/DVR DOCK
•[GAME] button : GAME DOCK
1 Press the remote controller’s appropriate INPUT SELECTOR button.
The selected input name appears in the display.
2 Press and hold down the INPUT SELECTOR
button selected in the Step 1 above for approximately 3 seconds to change the display name.
