Enjoying Audio Sources—Continued
MODE
SLEEP
DIMMER
Setting the Display Brightness
You can adjust the brightness of the display.
Press the remote controller’s [DIMMER] button repeatedly to select: dim, dimmer, or normal brightness.
You can also use the receiver’s [DIMMER] button (not European model).
Using the Sleep Timer (remote controller only)
With the sleep timer, you can set the receiver so that it turns off automatically after a specified period.
Press the remote controller’s [SLEEP] button repeatedly to select the required sleep time.
You can set the sleep time from 90 to 10 minutes in 10 minute steps.
The SLEEP indicator appears on the display when the sleep timer has been set, as shown. The specified sleep time appears on the display for about 5 seconds; then the previous display reappears.
SLEEP Indicator
To cancel the sleep timer, press the [SLEEP] button repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the [SLEEP] button. Note that if you press the [SLEEP] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.
BASS |
TREBLE |
BALANCE |
Using the Tone and Balance Controls
This section explains the following functions that can be used with any input source.
Adjusting the Bass
The BASS control adjusts bass sounds. Turn it up to make them louder. Turn it down to make them quieter. Normally, it should be set midway.
Adjusting the Treble
The TREBLE control adjusts treble sounds. Turn it up to make them louder. Turn it down to make them quieter. Normally, it should be set midway.
Adjusting the Balance
The BALANCE control is used to control the relative volume level of the left and right speaker systems.
Note:
If headphones are connected, the
BALANCE control has no effect.
Select the Audio Input
If a digital source is being input, the input selection will automatically switch to digital.