Can’t connect to the receiver from a Web browser
•If you’re using DHCP, your router may not always allocate the same IP address to the receiver, so if you find that you can’t connect to a server or Internet radio station, recheck the receiver’s IP address.
•Check the “Network Setup”.
USB Device Playback
Can’t access the music files on a USB device
•Make sure the USB device is plugged in properly.
•The receiver supports USB devices that support the USB mass storage device class. However, playback may not be possible with some USB devices even if they conform to the USB mass storage device class.
•USB memory devices with security functions cannot be played.
Others
Standby Power Consumption
•In the following cases, the power consumption may reach up to a maximum of 32 W:
1.You are using the Universal Port jack.
2.“Network Control” is set to “Enable” in the “Network Setup” setting.
The display doesn’t work
•The display is turned off when the Pure Audio mode is selected.
The functions don’t work
•To use , you must make an connection and an analog audio connection (RCA) between the component and receiver, even if they are connected digitally ( page 16).
•While Zone 2 is selected, the functions don’t work.
The receiver contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s malfunction. Before you record important data, make sure that the material will be recorded correctly.
Before disconnecting the power cord from the wall outlet, set the receiver to Standby.
