Onkyo TX-SA706 instruction manual 117

Troubleshooting—Continued

•To control an Onkyo component that’s connected via u, point the remote controller at the AV receiver/AV amplifier. Be sure to enter the appropriate remote con- trol code first (page 103).

•To control an Onkyo component that’s not connected via u, or another manufacturer’s component, point the remote controller at the component. Be sure to enter the appropriate remote control code first (page 102).

•The entered remote control code may not be correct. If more than one code is listed, try each one.

•If none of the codes work, use the Learning function to learn the commands of the other component’s remote controller (page 111).

Can’t learn commands from another remote controller

•When learning commands, make sure that the trans- mitting ends of both remote controllers are pointing at each other.

•Are you trying to learn from a remote controller that cannot be used for learning? Some commands cannot be learned, especially those that contain several instructions.

Recording

Can’t record

•On your recorder, make sure the correct input is selected.

•When the Pure Audio listening mode is selected, recording is not possible because no video signals are output. Select another listening mode.

Zone 2

There’s no sound

•Only components connected to analog inputs can be played in Zone 2.

Others

The sound changes when I connect my headphones

•When a pair of headphones is connected, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct, or Pure Audio.

The display doesn’t work

•The display is turned off when the Pure Audio listen- ing mode is selected.

How do I change the language of a multiplex source

•Use the “Multiplex” setting on the “Audio Adjust” menu to select “Main” or “Sub” (page 81).

The ufunctions don’t work

•To use u, you must make an uconnection and an analog audio connection (RCA) between the compo- nent and AV receiver/AV amplifier, even if they are connected digitally (page 39).

The functions Auto Power On/Standby and Direct Change don’t work for components connected via u

• These functions don’t work when Zone 2 is turned on.

When performing “Automatic Speaker Setup”, the measurement fails showing the message “Ambient noise is too high”.

•This can be caused by any malfunction in your speaker unit. Check if the unit produces normal sounds.

The following settings can be made for the S- Video and composite video inputs

You must use the buttons on the unit to make these set- tings.

1.While holding down the input selector button for the input source that you want to set, press the [SETUP] button.

2.Use the Left and Right [e]/[r] buttons to change the setting.

3.Press the [SETUP] button when you’ve finished.

• Video Attenuation

This setting can be made for the DVD, VCR/DVR, CBL/SAT, GAME/TV, or AUX input.

If you have a games console connected to the S-Video or composite video input, and the picture isn’t very clear, you can attenuate the gain.

Video ATT:OFF: (default).

Video ATT:ON: Gain is reduced by 2 dB.

The AV receiver/AV amplifier contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.

Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s malfunction. Before you record important data, make sure that the material will be recorded cor- rectly.

Before disconnecting the power cord from the wall out- let, set the AV receiver/AV amplifier to Standby.

117