Onkyo TX-SA706 Installing the Batteries, Aiming the Remote Controller, Notes

Remote Controller

Installing the Batteries

1 To open the battery compartment, press the small lever and remove the cover.

2 Insert the two supplied batteries (AA/R6) in accordance with the polarity diagram inside the battery compartment.

3 Replace the cover and push it shut.

Notes:

•If the remote controller doesn’t work reliably, try replacing the batteries.

•Don’t mix new and old batteries or different types of batteries.

•If you intend not to use the remote controller for a long time, remove the batteries to prevent damage from leakage or corrosion.

•Expired batteries should be removed as soon as possi- ble to prevent damage from leakage or corrosion.

Aiming the Remote Controller

To use the remote controller, point it at the AV receiver/AV amplifier’s remote control sensor, as shown below.

Remote control sensor

AV receiver/AV amplifier

STANDBY indicator

Approx. 16 ft. (5 m)

Notes:

•The remote controller may not work reliably if the AV receiver/AV amplifier is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights.

Keep this in mind when installing.

•If another remote controller of the same type is used in the same room, or the AV receiver/AV amplifier is installed close to equipment that uses infrared rays, the remote controller may not work reliably.

•Don’t put anything, such as a book, on the remote con- troller, because the buttons may be pressed inadvert- ently, thereby draining the batteries.

•The remote controller may not work reliably if the AV receiver/AV amplifier is installed in a rack behind col- ored glass doors. Keep this in mind when installing.

•The remote controller will not work if there’s an obstacle between it and the AV receiver/AV ampli- fier’s remote control sensor.

•When the remote control codes have been registered and you want to operate another component (page 102), or when you want to operate an Onkyo component without uconnection, point the remote controller at the other component to use it.

•When you want to operate an Onkyo component with

uconnection or an -compatible compo- nent connected via HDMI (page 104), point the remote controller at the AV receiver/AV amplifier’s remote control sensor.

14