Regency G36D installation manual LOG SET Installation, 02-75 02-55 02-52, 02-53 02-51 02-54

INSTALLATION

LOG SET INSTALLATION

Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.

The gas log kit (Part # 780-930) contains the following pieces:

a)02-75 Rear Log

b)02-55 Middle Left Log

c)02-50 Front Left Log

d)02-53 Center Left Log

e)02-51 Front Bottom Log

f)02-54 Center Right Log

g)02-52 Middle Right Log

h)	Embers		902-156
i)	Vermiculite		902-179
	02-75	02-55	02-52

BracketBracket

02-75

02-51

02-51 Notch

02-50 02-53 02-51 02-54

The "02" refer numbers (i.e. 02-75) are molded into the rear of each log.

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

2)Sprinkle the vermiculite all over the top of the base brick panel.

3)Place Log 02-75 on the rear log support pins with the fl at side to the back.

5)Position Log 02-53 across the cutouts in Logs 02-75 and 02-51 with the notch on the left side of the log fi tting into the 2nd grate tab.

02-53

02-75

02-75

Support Pins

4)Place Log 02-51 on the front right side of the burner. Push the back of the log against the 2 brackets with the notch on the bottom right side of the log fi tting into the right side of the grate.

2nd Grate Tab

02-51

Cutouts

02-51

UltraGlow® G36D Zero Clearance Direct Vent Gas Fireplace 27