Regency G36D Rigid Pipe Venting Systems, Horizontal or Vertical Terminations, Installation

INSTALLATION

RIGID PIPE VENTING SYSTEMS

Horizontal or Vertical Terminations

The minimum components required for a basic horizontal termination			Flat Wall Installation
are:		Wall Thickness		Vent Length Required
1	Horizontal Termination Cap	(inches)		(inches)
		4" -	5-1/2"	6"
1	90o Elbow
1	Rigid Pipe Adaptor	7" -	8-1/2"	9"

1Wall Thimble

1 Length of pipe to suit wall thickness (see chart)		10" - 1-1/2"	12"
Wall thickness is measured from the back standoffs to the inside mounting		9" - 14-1/2"	11" - 14-5/8" Adj. Pipe
		15" - 23-1/2"	17" - 24" Adj.
surface of termination cap. For siding other than vinyl furring strips may
be used, instead of the vinyl siding standoff, to create a level surface to		Corner Installation
mount the vent terminal. The Terminal must not be recessed into siding.		Wall Thickness	Vent Length Required
Measure the wall thickness including furring strips.
		(inches)	(inches)
If a Vinyl Siding Standoff is required (it must be used with vinyl siding),		3-1/4" - 6-3/4"	11" - 14-5/8" Adj. Pipe
measure to outside surface of wall without siding and add 2 inches.		7-3/4" - 16-1/4"	17" - 24" Adj. Pipe
Vertical		7-1/4" - 8-3/4"	6" + 12"
			9" + 9"
Terminal		4-1/4" - 5-3/4"	6" + 9"
Storm Collar
(Part # 953)	Vinyl Siding
	Standoff (Optional)		Alternate
Flashing	(Part #950)		Horizontal Ter-
943 or 943S			mination Caps
Ceiling Firestop		Horizontal
(Part # 963)		Termination Cap

(Part# 946-523/P)

	Wall Thimble
	(Part # 942)
Pipe Length	Adj.Pipe Length
	11" - 14-5/8"
	90o Elbow

24" Pipe Length

WARNING:

Do not combine venting components from different venting systems.

However use of the the AstroCapTM and FPI Riser is acceptable with all systems.

Rigid Pipe Adaptor

(Part# 510-994)

When using Rigid Vent piping other than Simpson Dura-Vent, 3 screws must be used to secure rigid pipe to adaptor.

This product has been evaluated by Intertek for using a Rigid Pipe Adaptor in conjunction with Dura-Vent Direct Vent GS, Selkirk Direct- Temp, Ameri Vent Direct venting and Security Secure Vent systems. Use of these systems with the Rigid Pipe adaptor is deemed acceptable and does not affect the Intertek WHI listing of components.

The FPI AstroCapTM and FPI Riser Vent terminal are certifi ed for installations using FPI venting systems as well as Simpson Dura-Vent® Direct Vent GS, American Metal Products Ameri Vent Direct Vent and Selkirk Direct-Temp. AstroCapTM is the proprietary trademark of FPI Fireplace Products International Ltd. Dura-Vent® and Direct Vent GS are registered and/or proprietary trademarks of Simpson Dura-Vent Co. Inc.

UltraGlow® G36D Zero Clearance Direct Vent Gas Fireplace 13