INSTALLATION
28)Install the 1/2" bushing to the heat shield.
29)Run the other end of the ground wire and DC spark generator wires through the bushing on the heat shield.
Heat Shield
30)Plug the DC spark generator wires to the DC Sparker
31 ) Connect the ground wire to the DC Sparker mounting bracket.
32)Mount the heat shield to the DC Sparker Secure into place with the velcro, which is provided in the kit.
33)F ind a location which is not too hot and is easy to reach for changing the battery. Note: It should be kept away from the chain.
Chain
34)Tie up the loose wire with the wire clip.
35)Check for gas leaks.
36)Check inlet and outlet pressures.
37)Check operation of fl ame control.
38)Check for proper fl ame appearance and glow on logs.
26 | UltraGlow® G36D Zero Clearance Direct Vent Gas Fireplace |
