INSTALLATION
STANDARD FLUSH
DOOR
The standard flush door comes with a black frame. To install the frame, simply hook the top door fl ange onto the top of the unit and swing the door towards the unit, diagram 1.
Use the hook to pull the spring out until you can put the hook into the slot on the bottom door bracket. Repeat for 2nd spring. See diagram 3.
Flush Louvers
1) | Install each top by clipping the louver lip |
| onto the top louver brackets ensuring that |
| each individual louver is centered from side |
| to side. |
2) | The bottom louver has a hinge that is |
| attached (2 screws per hinge) to the lip on |
| bottom of the unit. |
3) | Open the bottom louver. Pull the Burner |
| ON/OFF control box from inside the bottom |
| of the fi replace and position the slots in the |
Diagram 3
To remove the fl ush door, reverse the above steps.
Optional Flush Trim
bracket over the 2 screws on the left side |
of the bottom louver. Push down to lock into |
place. Tighten the screws. |
Attach the round magnets to the back of the
Diagram 1 top trim piece and to the bottom trim piece, then attach trim to the top and bottom of Flush
door.
Note: Top and bottom louvers are different.
Be careful that the glass gasket does not roll up; there must be a gap between the gasket and the door lip to ensure that the door sits securely on the unit. Diagram 2.
Diagram 2
30 | UltraGlow® G36D Zero Clearance Direct Vent Gas Fireplace |
