Onkyo TX-SA706 Controlling Other Components—Continued, Resetting REMOTE MODE Buttons

Controlling Other Components—Continued

Remote Control Codes for Onkyo Components Connected via u

Onkyo components that are connected via uare con- trolled by pointing the remote controller at the AV receiver/AV amplifier, not the component. This allows you to control components that are out of view, in a rack, for example.

1	Make sure the Onkyo component is con-
	nected with an u cable and an analog
	audio cable (RCA).
	See page 39 for details.
2	Enter the appropriate remote control code
	for the REMOTE MODE button.
	•	[DVD] button
		31612: Onkyo DVD player with u
	•	[CD] button
		71327: Onkyo CD player with u
	•	[TAPE] button
		42157: Onkyo cassette recorder with u
		(default)

See the previous page for how to enter remote control codes.

3 Press the REMOTE MODE button, point the remote controller at the AV receiver/ AV amplifier, and operate the component.

If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control an Onkyo component that’s not connected via u, use the following remote control codes:

• [DVD] button

30627: Onkyo DVD player without u(default)

• [CD] button

71817: Onkyo CD player without u(default)

Note:

If you connect an u-capable Onkyo MiniDisc recorder, CD recorder, or RI Dock to the TAPE IN/OUT jacks, or connect an RI Dock to the GAME/TV jacks, for

uto work properly, you must set the Input Display accordingly (see page 48).

Resetting REMOTE MODE Buttons

You can reset a REMOTE MODE button to its default remote control code.

1	While holding down the REMOTE
	MODE button that you want to
	reset, press and hold down the
	[AUDIO] button until the REMOTE
	MODE button lights up (about 3
	seconds).

(3 seconds)

2	Within 30 seconds, press the
	REMOTE MODE button again.

The REMOTE MODE button flashes twice, indicating that the button has been reset.

Each of the REMOTE MODE buttons is preprogrammed with a remote con- trol code. When a button is reset, its preprogrammed code is restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.

1	While holding down the
	[RECEIVER] button, press and
	hold down the [AUDIO] button
	until the [RECEIVER] button
	lights up (about 3 seconds).

(3 seconds)

2	Within 30 seconds, press the
	[RECEIVER] button again.
	The [RECEIVER] button flashes twice,
	indicating that the remote controller
	has been reset.

103