Onkyo TX-SA706 Zone 2—Continued, Setting the Powered Zone, The “Zone2” menu appears, Not Act

Zone 2—Continued

Setting the Powered Zone 2

If you’ve connected your Zone 2 speakers to the AV receiver/AV amplifier, as explained in “Connecting Your Zone 2 Speakers Directly to the AV receiver/AV ampli- fier” on page 97, you must set the “Powered Zone2” set- ting to “Act” (Activated).

1	Press the [RECEIVER] button fol-
	lowed by the [SETUP] button.
	The main menu appears onscreen.
	If the main menu doesn’t appear, make
	sure the appropriate external input is
	selected on your TV.

2 Use the Up and Down [q]/[w] but- tons to select “7. Hardware Setup”, and then press [ENTER]. The “Hardware Setup” menu appears.

7. Hardware Setup

1. Remote Control

2.Zone2

3.Tuner

4.Analog Multich

5.HDMI

3	Use the Up and Down [q]/[w] but-
	tons to select “2. Zone2”, and
	then press [ENTER].
	The “Zone2” menu appears.
	7–2. Zone2
	Powered Zone2	Not Act

4 Use the Up and Down [q]/[w] but- tons to select “Powered Zone2”, and use the Left and Right [e]/ [r] buttons to select:

Not Act:

ZONE 2 L/R speaker terminals not activated (Powered Zone 2 dis- abled).

Act:

ZONE 2 L/R speaker terminals activated (Powered Zone 2 enabled).

5	Press the [SETUP] button.
	The setup menu closes.

Notes:

•When “Act” is selected and Zone 2 turned on, the Zone 2 speakers connected to the ZONE 2 L/R speaker terminals output sound, but the surround back speakers connected to the SURR BACK L/R speaker terminals do not. When “Act” is selected and Zone 2 turned off, the surround back speakers output sound as normal.

•Powered Zone2 cannot be used if “Speakers Type” is set to “Bi-Amp” (see page 45).

•This procedure can also be performed on the AV receiver/AV amplifier by using its [SETUP] button, arrow buttons, and [ENTER] button.

98