Onkyo TX-SA706 5 6 7, Advanced Setup-Continued, If no center speaker is connected, select, “None”

Advanced Setup—Continued

5

6

7

Use the Up and Down [q]/[w] but- 8

tons to select “Front”, and then use the Left and Right [e]/[r] buttons to select a crossover fre- quency.

Note:

If the “Subwoofer” setting in step 4 is set to “No”, this setting is fixed at “Full Band”.

Use the Up and Down [q]/[w] but-
tons to select “Center”, and then
use the Left and Right [e]/[r]
buttons to select a crossover fre-
quency.	9
If no center speaker is connected, select
“None”.
Note:
If the “Front” setting in step 5 is set to
anything other than “Full Band”, “Full
Band” cannot be selected here.

Use the Up and Down [q]/[w] but- tons to select “Surround”, and then use the Left and Right [e]/ [r] buttons to select a crossover frequency.

If no surround left and right speakers are connected, select “None”.

Note:

If the “Front” setting in step 5 is set to anything other than “Full Band”, “Full Band” cannot be selected here.

Use the Up and Down [q]/[w] but- tons to select “Surr Back”, and then use the Left and Right [e]/ [r] buttons to select a crossover frequency.

If no surround back speakers are con- nected, select “None”.

Notes:

•If the “Surround” setting in step 7 is set to “None”, this setting cannot be selected.

•If the “Surround” setting in step 7 is set to anything other than “Full Band”, “Full Band” cannot be selected here.

•If the “Speakers Type” setting is set to “Bi-Amp” (page 45), or Powered Zone 2 is being used (page 98), this setting cannot be selected.

Use the Up and Down [q]/[w] but- tons to select “Surr Back Ch”, and then use the Left and Right [e]/[r] buttons to select:

1ch: Select if one surround back

speaker is connected.

2ch: Select if two (left and right) surround back speakers are connected.

Note:

If the “Surr Back” Setting in step 8 is set to “None”, this setting cannot be selected.

Continue with step 10 on the next page.

74