Onkyo TX-SR8260 Connecting the Power Cords of Other Components, Turning On the AV receiver

TX-NR702,602_En.book Page 38 Monday, July 26, 2004 11:05 AM

Connecting the AV receiver—Continued

Connecting the Power Cords of Other Components

The AV receiver has AC outlets on its rear panel that can be used to connect the power cords of AV other compo- nents that you intend to use with the AV receiver. These components can then be left turned on so that they turn on and off as and when the AV receiver is turned on and set to Standby.

Turning On the AV receiver

• American &			• Other
	Australian			models
	models
STANDBY/ON		STANDBY/ON			ON
						STANDBY

POWER

AC OUTLETS

	AC 120V 60 Hz
	SWITCHED
	TOTAL 120W 1A MAX.
AC OUTLETS
AC 230-240V 50 Hz
SWITCHED
TOTAL 100W MAX.
European and some	American model

Asian models

1

POWER

ON OFF

Set the [POWER] switch to the ON position ().

(Skip this step if you have the American or Australian model.)

The AV receiver enters Standby mode, and the STANDBY indicator comes on.

Note:

•The remote controller has no effect while the [POWER] switch in the OFF position.

Caution:

•Make sure that the total capacity of the components that you connect to the AC OUTLETS does not exceed the stated capacity (e.g., TOTAL 120 W).

Note:

•Onkyo components with jacks should be con- nected directly to wall outlets, not the AV receiver’s

AC OUTLETS.

•The number of AC OUTLETS, socket type, and total capacity depends on the country in which you pur- chased the AV receiver.

Connecting the RS232 Port

The TX-SR602/602E, TX-SR8260, American and Aus- tralian TX-SR702 do not have this port.

2

Remote

controller

ON

STANDBY

Press the [STANDBY/ON] button. Alternatively, press the remote controller’s [RECEIVER] button followed by the [ON] button.

The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.

To turn off the AV receiver, press the [STANDBY/ON] button. The AV receiver will enter Standby mode.

This port can be used to connect an external controller for controlling the AV receiver.

Connecting the Power Cord

•Before connecting the power cord, connect all your speakers and AV components.

•Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

38

Notes:

•Pressing the remote controller’s [ON] button once will turn on the AV receiver. Pressing it again will turn on

any components connected via .

•When the AV receiver is on Standby, it will turn on automatically when any one of its input selector but- tons is pressed.

Not for the American and Australian models:

•The AV receiver is shipped with the POWER switch in the ON position (). When the power cord is con- nected for the very first time, the AV receiver will go on Standby and the STANDBY indicator will light up.

•To completely shut down the AV receiver, set the POWER switch to the OFF position ().