Onkyo TX-SR8260 Setting the Powered Zone, Buttons to select a. Powered, Zone 2, and use the Left

TX-NR702,602_En.book Page 77 Monday, July 26, 2004 11:05 AM

Zone 2—Continued
Setting the Powered Zone 2		4	Use the Up and Down [ ]/[ ]
To use Zone 2, you must make this setting. It enables the			buttons to select “a. Powered
			Zone 2,” and use the Left and
speakers connected to the ZONE 2 SPEAKERS termi-
			ENTER
nals so that they produce sound when Zone 2 is used.			Right [ ]/[ ] buttons to select:
			Menu
			------------------------
			Basic Setup
			1.Initial Setup		-
			1-----------------------.Initial Setup
			1.Digital Input
1			1-3.Hardware Setup
			------------------------2.Component Video
			Advanced Setup
			3a..HardwarePowered Zone2Setup
			3.Surround Setup
			:Not Activated
			4.Audio Adjust
			b.Sp Impedance Minimum
			5.Listening Mode Preset
2, 3			6.Preference	:6ohms
	2–4		Not Activated: Zone 2 SPEAKERS
			terminals deactivated.
	1, 5		Activated: Zone 2 SPEAKERS termi-
			nals activated.
			When Zone 2 is activated and turned on
			(see page 78), the speakers connected
			to the ZONE 2 SPEAKERS terminals
			output sound, but the speakers con-
			nected to the SURROUND BACK
			SPEAKERS terminals do not. (When
			Zone 2 is activated but not used, the
			surround back speakers work as nor-
			mal.)
1 RECEIVER	Press the [RECEIVER] button fol-	5	Press the [SETUP] button.
	lowed by the [SETUP] button.
			The setup menu closes.

The main menu appears onscreen.

2

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “1. Initial Setup,” and then press [ENTER].

The Initial Setup menu appears.

Note:

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

3	Use the Up and Down [ ]/[ ]
	buttons to select “3. Hardware

ENTER	Setup,” and then press [ENTER].
	The Hardware Setup menu appears.

ENTER

77