Faxback Doc. #
High-Power In-Dash AM/FM Stereo CD Player
Features
120-2154/55
when you drive at night
the best possible sound, regardless of the signal level GENERAL
let you easily adjust high and low sounds
low volume levels
Page
Which terminal in my vehicles fuse box is for accessories?
Installation
BEFORE YOU BEGIN THE INSTALLATION
How do I connect a wire to the fuse box?
Be sure to avoid obstructions behind the mounting surface
Routing Speaker Wires
it is mounted
Removing the Shipping Screw
Connecting Ground, Power, and Optional Components
Black - Ground Red - +12V to Ignition Yellow - +12V to Battery
Using an Adapter Harness
4 Ohms. Your local RadioShack store carries a full line of speakers
Check the equalizer/boosters owners manual for directions
Black - Ground Red - + 12V to Ignition Yellow - + 12V to Battery
Connecting an Equalizer/Booster
Blue/White - AMP Remote Turn on 500 mA MAX
White - Front Left Speaker + White/Black - Front Left Speaker
Connecting Two Pairs of Speakers
7. Connect the green wire to the left rear speakers positive terminal
Gray - Front Right Speaker + Gray/Black - Front Right Speaker
Gray - Right Speaker + Gray/Black - Right Speaker Green - \
3. Connect the white wire to the left speakers positive terminal
White - Left Speaker + White/Black - Left Speaker
Green/Black - \\ Do Not Connect Violet Violet/Black
the tape while setting 2CH/4CH. Continue with Step
TESTING THE CONNECTIONS
2. Disconnect the wire harness and the antenna
MOUNTING THE STEREO
REMOVING THE STEREO FROM THE DASH
7. Reconnect the wire harness and the antenna
8. Slide the stereo into the sleeve until it locks into place
3. Press RLS to remove the stereos control panel
Note The keys are labeled to show their top edges
6. Disconnect the wire harness and the antenna
8. Reconnect the cable to the vehicle batterys negative - terminal
5. Remove the keys from the slots
INSTALLING THE CONTROL PANEL
High-Power In-Dash AM/FM Stereo CD
USING THE CONTROL PANEL
Player
Operation
SETTING THE CLOCK 1. Press ON/OFF to turn on the stereo
ADJUSTING THE SOUND
BASIC OPERATION TURNING THE STEREO ON AND OFF
If bAS, TRE, bAL, or FAd and the number disappear before you press
Follow these steps to store an FSM setting
number appear
The LOUD button is lit continuously while the stereo is on
DISPLAYING THE CLOCK
Note FSM I or FSM II blinks while you adjust the controls
1. Repeatedly press FSM until FSM I or FSM II appears
While the radio or a CD is playing, press CLOCK to display the clock
Storing Stations
Notes ST appears when an FM signal is received in stereo
MEMORY TUNING
2. Tune to the station you want to store
If the stereo could not find any strong stations, P
memory
Selecting a Stored Station
Scanning Stored Stations
CAUTIONS Play only CDs that have this mark on them COMPACT D I S C
3. Press + or - to increase or decrease the volume as desired
CD PLAYER OPERATION
DIGITAL SOUND
Note If you pause a CD for more then 5 minutes, the stereo turns off
5. To remove a CD from the CD player, press symbol. EJ cd appears
resume play, press CD again
SELECTING A TRACK
To begin scanning, press SCN/3. SCN appears during scanning
SWITCHING BETWEEN THE CD AND THE RADIO
SCANNING THE TRACKS
Problem
Troubleshooting
Indicator
Clean the CD see CD
CD Player
High-Power In-Dash AM/FM Stereo
and Maintenance
Care
REPLACING A FUSE
Replacing the Red Power Wires Fuse
CD CARE TIPS
3. Grasp the fuses plastic end and pull it out
6. If necessary, reinstall the stereo in the dash
7. Reconnect the cable to the vehicle batterys negative - terminal
5. Grasp the new fuses plastic end and push it in
IF Rejection
Signal-to-Noise S/N Ratio
88-108 MHz
Image Rejection
Number of Channels
Weight
Pick-Up System
Error Correction