Appendices
Command | Description | Remark (Parameter) |
|
|
|
Device’s IP address | http://xxx.xxx.xxx. | |
| LAN IP address is shown up if | xxx/index.html |
| LAN IP address is valid. |
|
| Wireless LAN IP address is |
|
| shown up if Wireless LAN IP |
|
| address is valid. |
|
Revision | The revision must follow a | 1.0.0 |
| major.minor.micro scheme. The |
|
| revision is only increased if the |
|
| command protocol is modified. |
|
vFor wide screen resolution (WXGA), the compatibility support is dependent on Notebook/PC models.
vThis AMX function is only to support AMX Device Discovery.
vThe broadcast information only send out through valid interface.
vBoth LAN and Wireless LAN interfaces could be supported at the same time.
vIf “Beacon Validator” was used. Please take care below information.
PJLink™ supported commands
The table below shows commands to control the projector using the PJLink™ protocol.
Command Description Remark (Parameter)
Command | Description |
| Remark (Parameter) |
|
|
| |
POWR | Power control | 0 = Standby | |
|
|
|
|
|
| 1 | = Power on |
|
|
| |
POWR? | Inquiry about the | 0 = Standby | |
| power state |
|
|
| 1 | = Power on | |
|
| ||
|
|
|
|
|
| 2 | = Cooling down |
|
|
|
|
|
| 3 | = Warming up |
|
|
| |
INPT | INPT Input switching | 11 = VGA1 | |
|
|
|
|
English 94
