EN
IMPORTANT If the heart rate icon does not appear on the display or is not flashing because no signal has been found, force a signal search. See “Signal Search” section for how to do this.
In the event that you experience a weak signal or your signal is disrupted by interference in the environment, follow the instructions below to identify and resolve the situation.
1.The signal is weak – the watch will only show “0”:
•Shorten the distance between the heart rate chest belt and watch.
•
•Check the batteries. If they are low or exhausted, the range may be less.
•Force a signal search (see “Signal Search” section).
2.Interference from another person’s heart rate monitor – their heart rate readings appear on your watch, or the watch shows “0”:
•Take the chest belt off for 12 seconds to automatically change your User ID. (The watch has 4 User ID’s. When the watch receives the chest belt signal it will tell you which User ID it has selected. Only products with a digital coding system have User ID capability.)
NOTE The heart rate readings may interfere with other users if the distance is less than 84 cm (33 inches).
3.The signal is jammed – the heart rate reading on your watch is flashing:
•There is too much interference in the environment for your heart rate monitor to function. Move to an area where the heart rate reading stops flashing.
WARNING Signal interference in the environment can be due to electromagnetic disturbances. These may occur near high voltage power lines, traffic lights, overhead lines of electric railways, electric bus lines or trams, televisions, car motors, bike computers, some motor driven exercise equipment, cellular phones or when you walk through electric security gates. Under interference, the heart rate and speed readings may become unstable and inaccurate.
SIGNAL SEARCH
To force a signal search:
1.Press MODE to enter SPEED, TRAIN or CHRONO Mode.
2. Press and hold MODE for 2 seconds. The 
with the outside flashing will appear to confirm a signal search is taking place. Whenever the watch is searching for the chest belt signal, make sure that the chest belt is no further than 10 cm (4 inches) from the watch.
10
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SE300_ |
| M_EN_USA.indd 10 |
|
|
|
|
| |||
|
| 8/31/06 12:13:01 PM | ||||||||
