REMOVE”.

4.Press SET.

5.Press ST/LAP/+ to select which device to delete.

6.Press SET to confirm selection.

CALIBRATING PAIRED DEVICE

The watch will not show “CAL DEVICE” if no device is paired.

You can calibrate by running, walking or inputting parameter. The parameter is the same value after you have successfully calibrated by running or walking.

If you want to calibrate the device immediately after pairing, go directly to step 4. Otherwise, start from the beginning.

CALIBRATE BY RUNNING OR WALKING

1.Press MODE repeatedly to select.

2.Press SET.

3.Press ST/LAP/+ repeatedly to select “CAL DEVICE”.

4.Press SET.

5.Press ST/LAP/+ to select “CAL BY RUN” or “CAL BY WALK”.

6.Press SET to confirm selection.

7.The watch will conduct a device search first, as

indicated by flashing

and

. Wait until

stops

flashing, then press SET to start calibration.

 

8. Ensure to complete

walking or running the selected

distance for calibration.

EN

 

ØIf calibration is successful, the watch will display

or

Run parameter Walk parameter

NOTE The Run parameter and Walk parameter is the value to enter when calibrating by inputting parameter.

ØIf calibration fails, the watch will display

NOTE The SZ909 chest belt should be calibrated both by running and walking.

SE833 EN 11.indd 11

11

6/1/09 10:07:22 AM

Page 11
Image 11
Oregon Scientific SE833 user manual Calibrating Paired Device, Calibrate by Running or Walking, Distance for calibration