13
OPEN / EJECT
1
3
2
4
R E C
SAVE
4
PUSH
TO CLOSE
3
1
2
3
1
1
2
2
Lens Cap and Grip Belt
To protect the Lens surface, attach the Lens Cap. Adjust the length of the
Grip Belt to the size of your hand.
1Attach the longer loop of the Lens Cap Cord to the Lens
Cap.
2Attach the shorter loop to the Grip Belt.
3Put your hand through the Grip Belt and adjust the length.
≥The removed Lens Cap can be hooked onto the Grip Belt 1. (When you
are not recording, be sure to keep the Lens Cap attached to the Lens for
protection.)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Attaching the Shoulder Strap
We recommend that you attach the Shoulder Strap before going outdoors to
record so as to avoid dropping the Camera/Recorder.
1Pass the tip of the Shoulder Strap through the Shoulder
Strap Holder on the Camera/Recorder and pull the Shoulder
Strap.
2Fold the tip of the Shoulder Strap, pass it through the
Shoulder Strap Length Adjuster, and pull it.
≥Pull it out more than 1 inch (2 cm) 2 from the Shoulder Strap Length
Adjuster so that it cannot slip off.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Inserting a Cassette
When power is supplied to the Camera/Recorder, the cassette can be taken
out without turning the Camera/Recorder on.
1Slide the [OPEN/EJECT] Lever 3 to the right and pull down
to open the Cassette Compartment.
2Insert a Cassette.
3Close the Cassette Compartment and lock the Cassette
Compartment by pressing the [PUSH TO CLOSE] mark.
4Close the Lower Cassette Compartment Cover.
≥For other notes, see page 46.
ªAccidental Erasure Prevention
Opening the accidental erasure prevention slider 4 on the cassette (by
sliding it in the [SAVE] arrow direction) prevents recording. To enable
recording, close the accidental erasure protection slider (by sliding it in the
[REC] arrow direction).