Using a Memory Card, Inserting a Memory Card

1, 2

OPEN

	TAPE CARD
3	1
PHOTO
SHOT

Using a Memory Card

ªInserting a Memory Card

Before inserting a Memory Card, be sure to turn the Camera/Recorder off.

1Slide the [OPEN] Lever to the right and open the Card Slot Cover.

2While holding the Memory Card with its cut corner facing right, insert it into the Card Slot.

3Close the Card Slot Cover.

ª[ACCESS] Lamp

While the Camera/Recorder is accessing the Card (reading, recording, playback, erasing, moving of images), the [ACCESS] Lamp 1 lights up. ≥While the [ACCESS] Lamp is on, never attempt to open the Card

Compartment, to pull out the Card, to turn off the Camera/Recorder power, or to switch the [TAPE/CARD] Selector. Such actions will damage the Card and cause the Camera/Recorder to malfunction.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Recording on the Memory Card

Still pictures can be recorded on a Card from the Camera/Recorder lens as well as from scenes that have already been recorded on a cassette.

The size of images that are recorded using this Camera/Recorder is approximately 1,680,000 pixels, and recording of images with a size that is larger than a million pixels is called mega-pixel still-picture recording.

F 7 1488ø

2	PHOTO
	SHOT

1TAPE CARD

1MENU 2

PUSH

VOL/JOG

BACK

LIGHT

Compared to images of normal recording, images that are created by mega-pixel still-picture recording can be printed out clearer.

ªCard Photoshot

Recording a picture through the Camera/Recorder lens (CAMERA Mode)

1Slide the [TAPE/CARD] Selector to [CARD].

2Set [PICTURE SIZE] on the [CARD SETUP] Sub-Menu to [1488t1128] or [640t480].

≥If you select [1488t1128], you can take pictures with higher resolution. (Mega-Pixel Recording)

3Press the [PHOTO SHOT] Button.

≥The [ø] Indication will light in red. 1

During Card Photoshot recording, the following functions are disabled.

≥Digital Zooming (l22)

≥Digital Effect Functions (l26, 27) ≥Title In/Creation (l37)

≥Frame Mode (l21)

≥The Camera/Recorder is automatically turned off when you leave it for about 5 minutes without performing any photoshot recording.

≥When recording dark scenes, set [LOW LIGHT SHOT] on the [CARD SETUP] to [AUTO] and then record. (l48)

Recording from a cassette (VCR Mode)

1Slide the [TAPE/CARD] Selector to [CARD].

2Start playback and press the [PHOTO SHOT] Button at the scene you want to record.

≥The size of the images input externally or recorded from a tape to the card becomes [640t480].

PUSH

≥While the image is being recorded, it stays still for a few seconds. ≥Please refer to “Recording to a Card from other equipment” (l48),

regarding the recording to a card from other equipment.

Selecting the quality of Card Photoshot images

1 Set [CAMERA FUNCTIONS] or [VCR FUNCTIONS] >> [CARD

SETUP] >> [REC MODE] >> a desired image quality (FINE,