Operation, Switch on the power | Panasonic AJ-D230HP specification

Operation

Switching on the power and inserting the cassette

Before attempting to operate the unit, make sure that it has been connected properly.

1	Switch on the power.
2	Insert the cassette tape.
	Insert the cassette tape into its prescribed position without forcing it in any way.
3	Check that the STOP lamp has lighted.
	When the tape is inserted, the cylinder starts rotating automatically, the tape is loaded,

and the unit is set to the stop mode.

Page 12

Image 12

Panasonic AJ-D230HP Operation, Switching on the power and inserting the cassette, Switch on the power

Contents

Operating Instructions FCC Note Table of Contents RS-232C Interface Features Introduction Controls and Their Functions Front PanelCounter display area Power switch LOCAL/MENU/REMOTE switchInput Select switch Cassette slot Volume control Volume recording level controlRemote control connector Reset button Connector section AC in connector Signal GND terminalHandle Video in connector Sync in connector Tapes TypeDescription Use of Panasonic consumer DV cassette tape is recommended Switching on the power and inserting the cassette Switch on the powerOperation Insert the cassette tape Stop mode Precautions for setting the still timer Recording Pause/still recording back-space assemble recording PlaybackCue and Review Still-picture playback Mode Audio OUT connectors Display tube Frame advanceSound selection Use the Audio OUT Select button to select the desired sound Set the VTR to the menu mode Repeat playbackMenu screen Set the VTR to the local mode Setting Description of operationOFF MEM Stop Repeat Continue Time Code and User’s Bit Time codeUser’s bit Setting the time code Setting the user’s bit Time code and user’s bit playback Display changes as shown below Operating mode Superimposed Display ScreensCharacters displayed Display position Set-up Default Settings Changing a settingSetting Upon completion of the setting, press the SET REC button Setting Set-up MenusBasic menu Description of settings Operation menu Type Format SEL setting Interface menu Memory Mode menu Tape Protect menu Setting Description of settings Time Code menu Video menu ColorMute LOW-RF RS-232C Interface Audio menu Interface specifications Example of wiring connectionsPin No Signal Communication parameters External interface specifications Sending format from personal computer to VTR Data formatReceiving format from VTR to personal computer Communication system Asynchronous, full duplex Baud rate STX QOP ETX ACK STX OEJ ETX STX QCD ETX ACK STX CD Command list Key commands Status commandVTR operation mode Code Send Description of operation Counter sense command Standby OFF commandsDeck ID command Error No Description of error Video Head Cleaning MaintenanceSet the VTR to the remote mode Condensation Input connectors Output connectorsDigital video Line IN/line OUT Service Centers

Operation

Switching on the power and inserting the cassette

Switch on the power.

Insert the cassette tape.

Check that the STOP lamp has lighted.