Playback, Cue and Review | Panasonic AJ-D230HP manual

Operation

Pause/still recording (back-space assemble recording)

1 Press the PAUSE/STILL button while the cassette tape is playing.

If the “AUTO BACK” set-up menu item has been set to ON, the tape will be rewound for 1 or 2 seconds starting at the position where the PAUSE/STILL button was pressed.

(See page 25)

2

3

Press the REC button to set the unit to the REC PAUSE mode.

The monitor display now switches to the E-E screen.

Press the PAUSE/STILL button to start the recording.

The tape runs to the position where the PAUSE/STILL button was pressed in step 1, and the recording is started.

<Note>

The E-E screen now appears.

Playback

1

2

Insert the cassette tape.

Press the PLAY button.

Normal playback is now commenced.

3	To stop playback, press the STOP button.
	The VTR is now set to the stop mode.

<Note>

During playback, check that the SERVO lamp is lighted. If the lamp is off or flashing, the images played back will appear disturbed.

Cue and Review

Keep pressing the FF or REW button during playback.

While the button is held down, the tape is cued or reviewed at approximately 10× normal tape speed.

Normal playback is restored when the button is released.

The cue track sound is output during cue or review if the “SEARCH CUE” set-up menu item has been set to ON. (See page 30)

Still-picture playback

Press the PAUSE/STILL button during playback.

When it is pressed again, normal playback is restored.

No sound is heard during still-picture playback.

15

Image 15

Panasonic AJ-D230HP Pause/still recording back-space assemble recording, Playback, Cue and Review, Still-picture playback

Contents

Operating Instructions FCC Note Table of Contents RS-232C Interface Introduction Features Controls and Their Functions Front PanelCounter display area Cassette slot Power switchLOCAL/MENU/REMOTE switch Input Select switch Reset button Volume controlVolume recording level control Remote control connector Connector section Sync in connector AC in connectorSignal GND terminal Handle Video in connector Use of Panasonic consumer DV cassette tape is recommended TapesType Description Insert the cassette tape Switching on the power and inserting the cassetteSwitch on the power Operation Precautions for setting the still timer Stop mode Recording Still-picture playback Pause/still recording back-space assemble recordingPlayback Cue and Review Use the Audio OUT Select button to select the desired sound Mode Audio OUT connectors Display tubeFrame advance Sound selection Set the VTR to the menu mode Repeat playbackMenu screen Set the VTR to the local mode Setting Description of operationOFF MEM Stop Repeat Continue Time Code and User’s Bit Time codeUser’s bit Setting the user’s bit Setting the time code Display changes as shown below Time code and user’s bit playback Display position Operating modeSuperimposed Display Screens Characters displayed Upon completion of the setting, press the SET REC button Set-up Default SettingsChanging a setting Setting Setting Set-up MenusBasic menu Operation menu Description of settings Interface menu Type Format SEL setting Tape Protect menu Memory Mode menu Time Code menu Setting Description of settings LOW-RF Video menuColor Mute Audio menu RS-232C Interface Communication parameters Interface specificationsExample of wiring connections Pin No Signal Communication system Asynchronous, full duplex Baud rate External interface specificationsSending format from personal computer to VTR Data format Receiving format from VTR to personal computer STX QOP ETX ACK STX OEJ ETX STX QCD ETX ACK STX CD Send Description of operation Command list Key commandsStatus command VTR operation mode Code Counter sense command Standby OFF commandsDeck ID command Description of error Error No Condensation Video Head CleaningMaintenance Set the VTR to the remote mode Line IN/line OUT Input connectorsOutput connectors Digital video Service Centers