RS-232C Interface, Audio menu | Panasonic AJ-D230HP manual

Set-up Menus

AUDIO menu

	Item		Setting
No.	Superimposed	No.	S u p e r i m p o s e d
No.	d i s p l a y	No.	d i s p l a y
700	SEARCH CUE	0000	OFF
		0001	ON
7 0 1	DV PBATT	0000	OFF
		0001	ON
702	PB MUTE	0000	OFF
		0001	ON
703	AUDIO REC IN	0000	CUT
		0001	FADE

Description of settings

This selects whether the cue audio signals are to be

output during search or during fast forwarding/rewinding (VV).

0:Signals are not output.

1:Signals are output.

This selects the audio output level during DV format playback.

0:Normal playback level

1:Output level is controlled only during DV format playback.

This selects whether the sound is to be muted during playback at the back-space assemble recording points.

0:Sound is not muted.

1:Sound is muted.

However, it may not be possible to mute the sound at the edit OUT point.

This selects the audio processing information at the back-space assemble recording points recorded on the tape.

0:Cut processing is selected

1:Fade processing is selected

The underlined number and item are the factory settings.

RS-232C Interface

The following functions can be controlled by using the RS-232C interface. 1. Basic operations

Eject stop

play rec/play fast forward rewind pause

2. Status checks

The current VTR mode can be checked.

30

Image 30

Panasonic AJ-D230HP operating instructions RS-232C Interface, Audio menu

Contents

Operating Instructions FCC Note Table of Contents RS-232C Interface Features Introduction Controls and Their Functions Front PanelCounter display area Input Select switch Power switchLOCAL/MENU/REMOTE switch Cassette slot Remote control connector Volume controlVolume recording level control Reset button Connector section Handle Video in connector AC in connectorSignal GND terminal Sync in connector Description TapesType Use of Panasonic consumer DV cassette tape is recommended Operation Switching on the power and inserting the cassetteSwitch on the power Insert the cassette tape Stop mode Precautions for setting the still timer Recording Cue and Review Pause/still recording back-space assemble recordingPlayback Still-picture playback Sound selection Mode Audio OUT connectors Display tubeFrame advance Use the Audio OUT Select button to select the desired sound Set the VTR to the menu mode Repeat playbackMenu screen Set the VTR to the local mode Setting Description of operationOFF MEM Stop Repeat Continue Time Code and User’s Bit Time codeUser’s bit Setting the time code Setting the user’s bit Time code and user’s bit playback Display changes as shown below Characters displayed Operating modeSuperimposed Display Screens Display position Setting Set-up Default SettingsChanging a setting Upon completion of the setting, press the SET REC button Setting Set-up MenusBasic menu Description of settings Operation menu Type Format SEL setting Interface menu Memory Mode menu Tape Protect menu Setting Description of settings Time Code menu Mute Video menuColor LOW-RF RS-232C Interface Audio menu Pin No Signal Interface specificationsExample of wiring connections Communication parameters Receiving format from VTR to personal computer External interface specificationsSending format from personal computer to VTR Data format Communication system Asynchronous, full duplex Baud rate STX QOP ETX ACK STX OEJ ETX STX QCD ETX ACK STX CD VTR operation mode Code Command list Key commandsStatus command Send Description of operation Counter sense command Standby OFF commandsDeck ID command Error No Description of error Set the VTR to the remote mode Video Head CleaningMaintenance Condensation Digital video Input connectorsOutput connectors Line IN/line OUT Service Centers