Panasonic AJ- G Connection cable, Confirmation of software version

Connection cable

A 10 m connection cable is attached to the unit. To extend the cable, use the optional dedicated cable. If several 10 m cables are connected in tandem, the power supply may be unstable due to voltage drops etc.

In an emergency, apply a higher voltage within a range from 11 V to 17 V for the power supply of DC 12 V to the camera recorder. If the input voltage to the unit is 8 V or less, operation becomes unstable. Refer to the following. A twisted-pair cable must be used for the control line of the 10-pin cable. Attenuation of the coaxial cable must be set to around –6 dB at maximum in 10 MHz.

Camera recorder side			Controller side
HR10A-10P-10P (Hirose Electric)			HR10A-10P10S (Hirose Electric)
CAM DATA (H)	1			1		CAM DATA (H)
		Twisted pair
CAM DATA (C)	2			2		CAM DATA (C)
CAM CONT (H)	3			3		CAM CONT (H)
		Twisted pair
CAM CONT (L)	4			4		CAM CONT (L)
ECU_ON	5				5	ECU_ON
Video output	6			6		Video input
GND (Video)	7			7		GND (Video)
Standby	8	1.5C - 2V		8		Standby
		3 h or less
+12 V (IN)	9			9		+12 V (IN)
		3 h or less
GND	10			10		GND
Connector GND						Connector GND

ENGLISH

Confirmation of software version

The software version for this unit can be confirmed in “VERSION” under SYSTEM in the unit menu. Confirm for questions.

E-32