Iris Range 1, 2, ATW Area 25%, 50%, 90% | Panasonic AK-HC1800N

Setting of menu items

2SETTING menu

[5]INTELLIGENT1

IRIS RANGE [1, 2, 3]

The iris control range during AGC operations is selected using this menu item.

1: F1.8 to F8

2: F1.8 to F11

3: F1.8 to F16

When the iris cannot be adjusted within the above range settings, use the gain (including PIX MIX, V MIX, and FRAME MIX), ND filter, and minus gain settings to adjust the range so that the appropriate level of exposure is achieved.

ATW AREA [25%, 50%, 90%]

The ATW white detection range is selected here.

The range is set to an area that is approximately 25 %, approximately 50 %, or approximately 90 % of the horizontal and vertical angles of view from the screen center, respectively.

ATW SPEED [1 to 5]

The ATW convergence speed can be set to any of 5 levels here.

The speed becomes faster as the figure increases.

- 55 -

Image 55

Panasonic AK-HC1800N operating instructions Iris Range 1, 2, ATW Area 25%, 50%, 90%, ATW Speed 1 to

Contents

Multi Purpose Camera Operating Instructions Do not Open FCC Note Indicates safety information Important Safety Instructions Accessories Contents New 2/3˝ 2.2 million-pixel CCD is employed H  CharacteristicsBit A/D conversion and brand-new DSP featured Introduction DON’TS Precautions for use Bottom view Rear view Front view  Lens mount  HD SDI output connector HD SDI OUT AK-HC1800N Interface cable specifications  Tally output connector Tally OUT How to set the lens How to install Configuration example 1 Connection of camera controller How to set up the system Configuration example 2 High-speed P/T system Configuration example 3 High-speed P/T system AW-PH650 BAR Control exercised from the AW-CB400 When the LCD panel is in the pedestal adjustment mode Procedure for camera menu operation AW-RP655 Mode How to set up the system Start shooting Operation procedureAdjust the white balance Adjust the black balance Auto iris power zoom lens How to adjustFlange back adjustment for zoom lens Lens iris gain volume adjustment Color temperature and white balance adjustment reference White balance adjustment Gen-lock adjustment Black balance adjustment Intelligent functions Automatic color temperature adjustment method Automatic video level adjustment method TOP menu Setting of menu itemsHow to display the menus  Using AK-HRP150G camera controller Black Shading Detection  Maintenance menuCorrectdig OFF, on Gamma PEDESTAL, GammaPedestal -200 to +200 Pedestal -100 to +100 Cine Gamma Select Video REC, Film REC Gamma OFF, onBlack Gamma OFF, on DRS OFF, on Flare 000 to FlareFlare OFF, on Knee Slope KNEE, White Clip When the Knee is set toManual Knee Point Knee Point -25.00% to +25.00% Knee Level 100% to 109% High Color OFF, on KNEE, White ClipKnee OFF, MANUAL, Auto White Clip OFF, on Knee Aperture OFF, on Detail Detail OFF, on Detail Source Detail Slim Detail OFF, on Skin GET OFF, on Skin Tone Detail Skin Tone DTL OFF, on Iris PEAK/AVE 000 to Iris Mode LENS, CAMGAIN, Auto Iris Iris Level 000 to Super Gain Mode S.GAIN1, S.GAIN2, S.GAIN3 PED Offset -200 to +200 35 to 0.75 DRS OFF -10 to +10 DRS on Matrix Table A, B Frame Mode Matrix Color Correction SAT/PHASE -63 to +63 LOW, MID, HIGH, S.GAIN1 to Setting menuLighting TUNGSTEN, Daylight Gain Select BAR SEL Matrix Table OFF, A, BColor Correction OFF, on Digital Extender OFF AWB OK FormatStatus OFF, on AWB Active Menu SEL Video MENU, Film Menu ABB OKOUT Range RGB Menu on BAR OFF, on Shutter Speed Shutter Shutter Mode OFF, ON, Synchro SD-HD Phase Fine -99 to +99 PHASE-COARSE -060 to +060PHASE-FINE -045 to +045 SD-HD Phase CRS -4 to +4 Protocol 1 to Protocol Intelligent MANUAL, AUTO, Lock INTELLIGENT1Gain -6dB to 72dB ND-FIL CLEAR, 1/4, 1/16, 1/64 ATW AGC AGC Speed 1 to INTELLIGENT1 Intelligent Mode AGC, ATW, AGC+ATWND Filter Select CLEAR, 1/4, 1/16, 1/64, Auto HI Light Detect 01 to INTELLIGENT1 AGC Gain Step NORMAL, MAX ATW Area 25%, 50%, 90% Iris Range 1, 2ATW Speed 1 to NORMAL, SPORTS, SN, User The AGC control mode is set here AGC Mode Frame MIX MIX +00dB, +06dB INTELLIGENT1 SUB Menu INTELLIGENT2 INTELLIGENT2 Intelligent SET Iris on Lock LOCK, MANUAL, Panel ATW Width 1 to Camera ID menu Execute Mode LOAD/STOREFile Operation menu LOAD/STORE from Menu list Setting of menu items Maintenance Color SAT/PHASE Correction Setting of menu items Unit inch mm Appearance Input/output signal Specifications Eastern Zone