How to set up the system
Configuration example 4: Controlling the camera from the
AW-RP655 or AW-RP555 controller
When installing the camera on the AW-PH650 outdoor pan/tilt head, refer to the operating instructions of the AW-PH650.
When placing the camera on the AW-PH650 and controlling it from the AW-RP655 or AW-RP555 controller, select “4” as the PROTOCOL setting of the AK-HC1800N, and set the camera control selector switch inside the housing of the AW-PH650 to “CB400.”
When using G/L signals, select “DSUB” as the GEN-LOCK INPUT setting of the AK-HC1800N. Be absolutely sure to perform and check these settings prior to installation.
AK-HC1800N
When mounting the camera on the pan/tilt head:
Select “4” as the PROTOCOL setting.
Select “DSUB” as the GEN-LOCK INPUT setting.
AK-HC1800N
When connecting this unit directly to the controller:
Select “3” as the PROTOCOL setting. Set GEN-LOCK INPUT as required.
| AW-PH650 | | | |
| Set the camera control | MULTI | |
| selector switch inside the | |
| | | |
| housing to “CB400”. | SDI | POWER | Outdoor |
AC adapter | | OUT |
| | | pan/tilt |
AW-PS510AN | | | |
| | | head |
| | | |
| | | | AW-PH650 |
Controller | RJ-45 relay adapter | | | |
AW-RP655 or | | | |
AW-RP555 | | | | |
| 10BASE-T (UTP | G/L input | To be locally |
| purchased |
| category 5) straight |
| | |
| cable | | |
| AC adapter | | |
| AW-PS510AN | | |
When the AK-HC1800N, to which the motor drive lens is connected, has been directly connected to the AW-RP655 or AW-RP555 controller, zooming and focusing can be controlled using the controller’s joystick.
- 17 -
