Installation and connections (Be sure to ask your dealer.)

wwHow to install the option boards

For details, refer to the operating instructions of the option board concerned.

The instructions set forth in the operating instructions of the option boards listed below describe the steps to take when the boards are to be installed in the AV-HS400AN or AV-HS400AE.

When reading these instructions, change the wording used for all references to this model and its slots with the actual model and actual slots.

<Changes in the wording given for option slots and signal lines>

Option boards and wording used in operating instructions

When the option boards are to be installed in the

AV-HS410

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

AV-HS04M1, AV-HS04M2,

SLOT 1

INPUT 5, INPUT 6

SLOT A

IN A1, IN A2

AV-HS04M3, AV-HS04M6

SLOT 2

INPUT 7, INPUT 8

SLOT B

IN B1, IN B2

 

AV-HS04M4, AV-HS04M5,

SLOT 1

OUTPUT 3, OUTPUT 4

SLOT A

OUT A1, OUT A2

AV-HS04M7

SLOT 2

OUTPUT 5, OUTPUT 6

SLOT B

OUT B1, OUT B2

 

<Changes in wording used for setting switch SW501 of AV-HS04M6>

 

Wording used in operating instructions

When the option board is to be installed in the

 

AV-HS410

 

 

 

 

 

 

 

 

 

 

 

Switch No.

 

Switch No.

1

Y/C separation mode

1

Y/C separation mode

2

(INPUT5, 7)

2

(IN A1, IN B1)

3

Y/C separation mode

3

Y/C separation mode

4

(INPUT6, 8)

4

(IN A2, IN B2)

5

NTSC SETUP

5

NTSC SETUP

6

 

6

 

7

Reserved

7

Reserved

8

 

8

 

When an option board (AV-HS04M1, AV-HS04M2 or AV-HS04M6) has been installed in the unit, the settings established by the selection positions for the following switches are not reflected.

Select the settings using the unit’s setting menus.

 

Wording used in operating instructions

AV-HS410 setting menu

 

 

 

 

 

 

 

Switch No.

Input menu Up Converter2 sub menu

4

Screen position

Edge Crop Pos

5

 

 

6

Gamut limiter

Limiter

7

 

 

8

Color matrix conversion

Color Convert

Notes

ppBefore installing or removing an option board, turn off the power, and disconnect the power plug.

ppBefore coming into physical contact with the option board, touch your hand to metal that has been grounded to discharge the static electricity in your body.

A safe way to proceed is to wear an anti-static wrist strap.

The option board may be damaged if you touch the board with static still in your body.

ppAvoid damage to the option board by not dropping it or subjecting it to strong shocks or vibrations. pp After removing an option board, be absolutely sure to attach the blank panel.

pp When installing or removing an option board, take care not to hurt yourself on the edges or metal parts of the board.

12