Panasonic AWHE50HN manual Press the SET button for 2 seconds, Press the AWC button

White balance adjustment

5Press the [] or [] button to bring the cursor to “AWB Mode”.

6Press the [] button.

“AWB Mode” starts blinking.

7Press the [] or [] button to change the AWB mode to be used to “AWB A” or “AWB B”, and press the [] button to enter the selection.

8Press the [MENU] button for 2 seconds.

The menu display is exited.

9Press the [SET] button for 2 seconds.

The auto white balance adjustment (AWB) is performed, and the white balance setting is entered.

pp The white balance cannot be adjusted when color

bars are displayed. Press the [MODE] button to switch to the camera picture.

ppWhen the white balance adjustment is completed successfully, “AWB OK” appears in the center of the screen.

AWB OK

ppWhen the adjustment has failed, an error message such as “OUT RANGE NG”, “HIGH LIGHT NG”, “LOW LIGHT NG” or “ATW NG” is displayed.

When performing the operations using the controller

When the AW‑RP655 or AW‑RP555 is connected:

2Press the [A] button or [B] button of [WHITE BAL] to select “AWB A” or “AWB B” for the white balance.

The selected button’s lamp lights.

ppThe white balance setting is not entered if “ATW” has been selected.

3Press the [AWC] button.

The auto white balance adjustment (AWB) is executed, and the white balance setting is entered.

The [AWC] button’s lamp blinks while the white balance is being adjusted, and its lamp goes off when the adjustment is completed successfully. Its lamp lights if the white balance could not be adjusted.

ppIf color bars have been selected (the [MODE] button or [BAR/CAM] button’s lamp lights) or if ATW is selected (the [ATW] button’s lamp lights), it means that the [AWC] button is not working or that the auto white balance adjustment has failed. (The button’s lamp lights.)

Note

ppIn the case of the AW‑RP655, even when it is not possible to adjust the white balance, the [AWC] button’s lamp will not light and after blinking it will go off.

23