Panasonic AWHE50HN manual Subnet mask, Default gateway

Web setting screen

Subnet mask

<Initial setting: 255.255.255.0>

Input the unit’s subnet mask here if the DHCP function is not going to be used.

Default gateway

<Initial setting: 192.168.0.1>

Input the unit’s default gateway if the DHCP function is not going to be used.

ppMultiple IP addresses cannot be used for the default gateway even when the DHCP function is used.

For details on the DHCP server settings, consult your network administrator.

DNS

<Initial setting: Manual>

Whether the DNS server address is to be acquired automatically (Auto) or manually (Manual) is input here. If “Manual” has been selected, the DNS settings must be established.

If “Auto” is selected when the DHCP function is going to be used, the DNS server address is acquired automatically.

For further details, consult your system administrator.

Primary server address Secondary server address <Initial setting: blank>

Input the IP address of the DNS server if the “Manual” setting has been selected for “DNS”.

For details on the IP address of the DNS server, consult your system administrator.

HTTP port [1 to 65535] <Initial setting: 80>

The port number is allocated here separately.

The following port numbers are used by the unit therefore cannot be used.

Port numbers already used 20, 21, 23, 25, 42, 53, 67, 68, 69,

110, 123, 161, 162, 554, 995, 10669, 10670, 59000 to 59999, 60000 to 61000

Line speed <Initial setting: Auto>

Select one of the following data line speeds. Normally, it is recommended that the “Auto” default setting be used.

Auto	The line speed is set automatically.
100 M-Full	The line speed is set to 100 Mbps full
	duplex.
100 M-Half	The line speed is set to 100 Mbps half
	duplex.
10 M-Full	The line speed is set to 10 Mbps full duplex.
10 M-Half	The line speed is set to 10 Mbps half duplex.

FTP access to camera <Initial setting: Forbid>

Whether FTP access to the camera is to be allowed is set by selecting “Allow” or “Forbid”.

Bandwidth control(bit rate) <Initial setting: Unlimited>

Select one of the following data bandwidth settings.

Unlimited	384 kbps	2048 kbps
64 kbps	512 kbps	4096 kbps
128 kbps	768 kbps	8192 kbps
256 kbps	1024 kbps

Easy IP Setup accommodate period <Initial setting: Unlimited>

Select “20min” or “Unlimited” as the time for enabling the operation of the network settings from the Easy IP Setup Software.

20min	The setting operations from the Easy IP
	Setup Software are enabled for 20 minutes
	after the camera has started operating.
Unlimited	The setting operations from the Easy IP
	Setup Software are enabled at all times.

70