Panasonic DMC-G2K operating instructions Inserting and Removing the Card optional/the Battery

Preparation

Inserting and Removing the Card (optional)/the Battery

•Check that this unit is turned off.

•Close the flash.

•We recommend using a Panasonic card.

Slide the release lever in the direction of the arrow and open the card/battery door.

• Always use genuine Panasonic batteries (DMW-BLB13PP).

• If you use other batteries, we cannot guarantee the quality of this product.

Battery: Insert until it is locked by the lever A being careful about the direction you insert it. Pull the lever A in the direction of the arrow to remove the battery.

Card: Push it fully until it clicks being careful about the direction you insert it. To remove the card, push the card until it clicks, then pull the card out upright.

B: Do not touch the connection terminals of the card.

•The card may be damaged if it is not fully inserted.

1:Close the card/battery door.

2:Slide the release lever in the direction of the arrow.

• If the card/battery door cannot be completely closed, remove the card, check its direction and then insert it again.

Note

•Remove the battery after use.

•Do not remove the battery while the power is on as the settings on the camera may not be stored properly.

•The supplied battery is designed only for the camera. Do not use it with any other equipment.

•The battery will be exhausted if left for a long period of time after being charged.

•Before removing the card or battery, turn the camera off, and wait until the status indicator has gone off completely. (Otherwise, this unit may no longer operate normally and the card itself may be damaged or the recorded pictures may be lost.)

28 VQT2S30