Panasonic DMC-G2K Press 3/ 4 to select PC, and then press, Double-click Dcim folder

Connecting to other equipment

Acquiring of still pictures and [MOTION JPEG] motion pictures

(other than [AVCHD Lite] motion pictures)

Preparations: Turn the LCD monitor so the LCD will show out.

Turn on the camera and the PC.

AUSB connection cable (supplied)

•Check the directions of the connectors, and plug them straight in or unplug them straight out. (Otherwise the connectors may be bent out of shape which may cause malfunction.)

BAlign the marks, and insert.

CDC cable (DMW-DCC3; optional)

•Use a battery with sufficient battery power or the AC adaptor (P181). If the remaining battery power becomes low while the camera and the PC are communicating, the status indicator blinks and the alarm beeps.

Refer to “Disconnecting the USB connection cable safely” (P172) before disconnecting the USB connection cable. Otherwise, data may be destroyed.

Connect the camera to a PC via the USB connection cable A (supplied).

•Do not use any other USB connection cables except the supplied one. Use of cables other than the supplied USB connection cable may cause malfunction.

Press 3/4 to select [PC], and then press		USB MODE
		PLEASE SELECT
[MENU/SET].
		THE USB MODE
• If [USB MODE] (P37) is set to [PC] in the [SETUP] menu in		PictBridge(PTP)
		PC
advance, the camera will be automatically connected to the PC	SELECT		SET
				MENU
without displaying the [USB MODE] selection screen. Since
there is no need to set this each time you connect to the PC, it
is convenient.

•When the camera has been connected to the PC with [USB MODE] set to [PictBridge(PTP)], a message may appear on the PC’s screen. Select [Cancel] to close the screen, and disconnect the camera from the PC. Then set [USB MODE] to [PC] again.

Double-click on [Removable Disk] in [My Computer].

•When using a Macintosh, the drive is displayed on the desktop. (“LUMIX”, “NO_NAME” or “Untitled” is displayed.)

Double-click [DCIM] folder.

VQT2S30 171