Panasonic DMC-LS2 Connecting to a PC, Press 3 to select PC and then press MENU/SET, Windows

Connecting to other equipment

Connecting to a PC

SCN1 SCN2

You can acquire recorded pictures to a PC by connecting the camera and the PC. The software [LUMIX Simple Viewer] (for Windows®) in the CD-ROM (supplied) allows you to easily acquire pictures recorded with the camera to a PC, print them and send them by e-mail.

If you use Windows 98/98SE, install the USB driver and then connect it to the computer.

For information about installing [LUMIX Simple Viewer] etc., refer to the separate operating instructions for PC connection.

DIGITAL

V.OUT

DC IN 3V

A: USB connection cable (supplied)

B: AC adaptor (DMW-AC6; optional)

•Use batteries with sufficient battery power or the AC adaptor (DMW-AC6; optional).

•Turn the camera off before inserting or removing the cable for the AC adaptor (DMW-AC6; optional).

1 Turn on the camera and the PC.

2 Connect the camera to a PC via the USB connection cable A (supplied).

•Connect the USB connection cable with the [ ] mark facing the [1] mark on the [DIGITAL] socket.

•Hold the USB connection cable at C and insert straight in or take straight out. (If you forcibly insert the USB connection cable at a slant or upside down you can deform the connection terminals and damage the camera or the connected equipment.)

ACCESS

D: This message appears during data transfer.

3 Press 3 to select [PC] and then press [MENU/SET].

USB MODE

PLEASE SELECT

THE USB MODE

	PC
	PictBridge(PTP)	MENU
SELECT	SET MENU	SET

•If you set [USB MODE] in the [SETUP] menu to [PC] in advance, it is not necessary to set this every time you connect to a PC. (P22)

•If you set [USB MODE] to [PictBridge (PTP)] and then connect the camera to the PC, messages may appear on the screen of the PC.

Select [Cancel] to close the messages and disconnect the camera from the PC. Set [USB MODE] to [PC] again.

[Windows]

The drive appears in the [My Computer] folder.

75

VQT0V10