Using the DC coupler (optional) instead of battery

By using the AC adaptor (optional) and DC coupler (optional), you can record and play back without worrying about the remaining battery charge.

The optional DC coupler can only be used with the designated Panasonic AC adaptor.

Insert DC coupler instead of battery

Open DC coupler cover

If difficult to open, press the DC coupler cover from inside to open it.

Close the card/battery door and slide the door in until you hear a locking sound

Plug AC adaptor into power outlet

DC IN socket

DC coupler

Connect AC adaptor to DC IN socket of DC coupler

AC adaptor

DC coupler cover

 

To connect, face the cable mark to the LCD monitor

Always use a genuine Panasonic AC adaptor (optional).

Use the AC adaptor and DC coupler specifically for this camera. Using other adaptors or couplers could cause camera failure.

The possibility to install the camera on a tripod or unipod when the DC coupler is connected depends on the type of tripod or unipod.

The camera cannot stand upright when the AC adaptor is connected. If you are leaving the camera on a surface as you work, it is recommended to place it on a soft cloth.

When the AC adaptor is connected, always remove the AC adaptor when opening the card/battery door.

Remove the AC adaptor and DC coupler when not in use and close the coupler cover. Also read the AC adaptor and DC coupler operating instructions.

VQT3E45 13

Page 13
Image 13
Panasonic DMC-S1K Using the DC coupler optional instead of battery, Connect AC adaptor to DC in socket of DC coupler