Panasonic DMCTZ1K, DMC-TS1 Memory Card Error Format this CARD?, Memory Card Parameter Error

Others

[MEMORY CARD ERROR FORMAT THIS CARD?]

•This card has a format which is not recognized by the camera.

>Format the card again with the camera after saving necessary data on a PC etc. (P32)

[PLEASE TURN CAMERA OFF AND THEN ON AGAIN]/[SYSTEM ERROR]

•This message will be displayed if the lens did not operate properly.

>Turn the camera off and on. If the message persists, contact the dealer or your nearest Service Center.

[MEMORY CARD PARAMETER ERROR]

>Use a card compatible with this unit. (P21)

•You can only use an SDHC Memory Card if using cards with 4 GB or more capacity.

[MEMORY CARD ERROR PLEASE CHECK THE CARD]

•An error has occurred accessing the card.

>Insert the card again.

>Insert a different card.

[READ ERROR/WRITE ERROR PLEASE CHECK THE CARD]

•It has failed to read or write data.

>Remove the card after turning the power [OFF]. Insert the card again, turn the power on, and try to read or write the data again.

•The card may be broken.

>Insert a different card.

[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE WRITING SPEED OF THE CARD]

•It is recommended to use a card with SD Speed Class¢ with “Class 6” or higher when

recording motion pictures.

¢SD speed class is the speed standard regarding continuous writing.

•When you set the picture quality to [], [ ] or [ ], we recommend using a high-speed card with “10MB/s” or greater displayed on the package.

•In the event that it stops even after using a “10MB/s” card or higher, the data writing speed has deteriorated so it is recommended to make a backup and then format (P32).

•Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording may stop in the middle.

[A FOLDER CANNOT BE CREATED]

•A folder cannot be created because there are no remaining folder numbers that can be used. (P121)

>Format the card after saving necessary data on a PC etc. (P32) If you execute [NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100. (P29)

[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]

•The AV cable is connected to the camera.

>Press [MENU/SET] if you want to delete this message at once.

>Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P30)

•This message also appears when the USB connection cable is connected to the camera only. In this case, connect the other end of the USB connection cable to a PC or a printer. (P118, 122)

VQT1Z45 133