Panasonic DMC-TS3 owner manual Adjusting the compass

Recording

Note

•It may not measure correctly when you measure with this unit upside down.

•The bearing measurement value may be affected in locations with weak geomagnetism.

•It may not measure accurately if close to the following objects:

–Permanent magnets (metals in magnetic necklaces, etc.)/metallic objects (steel desks, lockers, etc.)/high-voltage lines or overhead wires/household appliances (TVs, PCs, speakers, etc.)

•It may not measure accurately in the following locations:

–Inside cars/trains/ships/aeroplanes/rooms (when the steel beams are magnetized)

Adjusting the compass

The bearing may not be measured due to disturbance of the geomagnetism depending on the environment, such as when there is something emitting strong magnetism nearby, etc. [ ] is displayed on the compass when the bearing cannot be measured, and a message prompting to adjust is displayed. In such a case, perform [Calibrate compass].

Select [Calibrate compass] from the [GPS/Sensor] menu. (P44)

Securely hold the unit vertically, and adjust by turning it in a figure 8 a few times rolling your wrist.

•An adjustment completed message is

displayed when the adjustment is successful.

Note

•Perform the adjustment with the strap around your wrist to avoid dropping the unit.

•When the adjustment fails, move to a location with no effect from surrounding magnetism, and perform the adjustment again.

- 91 -