On the unit’s display |
|
|
| Page |
|
|
|
|
|
F99 | ≥The unit fails to operate properly. Press [POWER Í/I] on the main unit to switch | — | ||
|
| the unit to standby for 3 seconds. Now press [POWER Í/I] on the main unit |
| |
|
| again to turn the unit on. |
| |
HDMI ONLY | ≥Some | — | ||
NET | ≥Displays while VIERA CAST is starting up. | — | ||
No PLAY | ≥There is a viewing restriction on a | 32 | ||
No READ | ≥The media is dirty or badly scratched. The unit cannot play. | — | ||
PLEASE WAIT | ≥The unit is carrying out internal process. This is not a malfunction. You cannot | — | ||
|
| operate the unit while “PLEASE WAIT” is displayed. |
| |
| ≥When connected to TV(VIERA) with “HDAVI Control 4”, and power supply is | — | ||
|
| turned off by the “Auto power |
| |
REMOVE | ≥The USB device is drawing too much power. Remove the USB device. | 19 | ||
SET | ≥The remote control and main unit are using different codes. Change the code on | 36 | ||
(“ ” stands for a number.) |
| the remote control. |
| |
|
|
| Press and hold [OK] and the indicated number button at the |
|
|
|
|
| |
|
|
|
| |
|
|
| same time for more than 5 seconds. |
|
|
|
|
| |
UNFORMAT | ≥You inserted an unformatted | — | ||
|
| or |
| |
UNSUPPORT | ≥You have inserted a media the unit cannot play. | 6, 7 | ||
| ≥You tried to operate with a | 7 | ||
U11 | ≥The video head is dirty. Perform the cleaning. | — | ||
U59 | ≥The unit is hot. | — | ||
|
| The unit switches to standby for safety reasons. Wait for about 30 minutes until |
| |
|
| the message disappears. |
| |
|
| Select a position with good ventilation when installing the unit. Do not block the |
| |
|
| cooling fan on the rear of the unit. |
| |
U72 | ≥The HDMI connection acts unusually. | — | ||
U73 |
|
| ||
|
|
| ||
|
|
| ||
Hor F | ≥There is something unusual. (The service number displayed after H and F | — | ||
|
| depends on the unit’s condition.) |
| |
| ≥Check the unit using the troubleshooting guide. If the service number does not | |||
|
| disappear, do the following. |
| |
|
| 1 Disconnect the plug from the AC outlet, wait a few seconds, then reconnect it. |
| |
|
| 2 Press [POWER Í/I] to turn the power on. (The unit may be fixed.) |
| |
|
| If the service number does not disappear despite doing the above, request |
| |
|
| service from the dealer. Inform the dealer of the service number when requesting |
| |
|
| service. |
| |
START | ≥The system is being restarted during the firmware update. Please do not turn off | 16 | ||
|
| power. |
| |
UPD/ | ≥The firmware is being updated. | 16 | ||
FINISH | ≥The firmware update is complete. | 16 | ||
|
|
|
|
|
Reference
39
RQT9412
